Overview
The G2 Dana 44 JK Front Reverse 4.56 Ratio Ring and Pinion, part number 2-2051-456R, is a 4.56-ratio front reverse gear set for the Dana 44 front axle in the Jeep Wrangler JK. It is made for a 3.73 and down carrier.
The set is made from computer heat-treated 8620 steel, shot peened and double lapped, and built to O.E. specifications.
Key features
- 4.56 gear ratio in a front reverse design
- For use with a 3.73 and down carrier
- Dana 44 JK front axle
- Heat-treated 8620 steel
Front reverse setup tips
The Dana 44 JK front axle is the axle at the front of the Wrangler JK, and this set is built for that position only. A 4.56 ratio gives a middle ground between pulling power and highway speed, with engine speed at cruise a bit higher than with taller gearing. Make sure the axle is the front unit before ordering, because a reverse layout will not match a rear housing.
Tire size changes the effective gearing, so a set of larger tires can feel like a different ratio. Shops usually check the gear contact pattern with marking compound and adjust shims until it sits correctly. Keep pinion depth and carrier preload where the setup check leaves them, since small changes affect noise.
Replacing the carrier bearings, pinion bearings, and pinion seal with the gears is common, because the old parts wore to the previous pattern. After the break-in period, check gear oil for fine metal and listen for changing whine.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2051-456R |
| UPC | 631410111125 |
| Axle type | Dana 44 JK |
| Axle location | Front |
| Gear ratio | 4.56 |
| Carrier | For use with 3.73 and down |
| Warranty | 10 years. |
Vehicle fitment
The title places this set on the front Dana 44 axle of the Jeep Wrangler JK (2007-2018). The set is not limited to a single trim, because the front axle was used across the JK range.
Confirm your vehicle’s year, model and trim before ordering, and make sure the front axle is a Dana 44.
Installation notes
Front reverse gears should be set up by a shop with the right pinion depth and carrier preload tools, then broken in gradually.















