Overview
The G2 Dana 44 JK Rear 5.13 Ratio Ring and Pinion, part number 2-2052-513, is a 5.13-ratio gear set for the rear Dana 44 axle in the Jeep Wrangler JK. It is for the rear axle location.
The gears are made with current technology and materials and built for demanding use.
Key features
- 5.13 gear ratio
- Dana 44 JK rear axle
- Rear axle location
Working with a larger gear change
A 5.13 ratio is a bigger step from stock than a moderate ratio, so the change in engine speed at cruising speed is more noticeable. Tire size matters here too. Larger tires lower the effective gearing, and a 5.13 set paired with them can bring engine speed closer to a normal range. Drivers who mostly crawl off road often feel the benefit most, while daily highway trips can feel louder.
Gear mesh, backlash, and pinion preload decide whether the new set runs quietly and lasts. Use a dial indicator and marking compound to check the tooth contact pattern before the cover goes back on. A rushed setup is a common cause of early noise and failure, so plan time for break-in and a recheck of the fluid level after the first trail runs.
- Check tooth contact with marking compound
- Recheck fluid and bolts after the first runs
- Confirm speedometer calibration after the change
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2052-513 |
| UPC | 631410094619 |
| Axle type | Dana 44 JK |
| Axle location | Rear |
| Gear ratio | 5.13 |
Vehicle fitment
This 5.13 rear set is for the Dana 44 axle of the Jeep Wrangler JK (2007-2018). It covers the JK model years rather than a single trim.
Confirm your vehicle’s year, model and trim before ordering, and check that the axle is the rear Dana 44.
Installation notes
A 5.13 rear set is a larger gearing change, so the mesh, backlash and preload should be checked before the axle is returned to service.












