Overview
The G2 Dana 44 JK Front Reverse 5.13 Ratio Ring and Pinion, part number 2-2051-513R, is a 5.13-ratio gear set for the front Dana 44 axle in the Jeep Wrangler JK. It is for use with a 3.73 and down carrier.
The gears are made from computer heat-treated 8620 steel, shot peened and double lapped. The set comes with a 10-year warranty.
Key features
- 5.13 gear ratio in a front reverse design
- For use with a 3.73 and down carrier
- Dana 44 JK front axle
- Heat-treated 8620 steel
Break-in and shop setup
A 5.13 ratio is a strong gearing change for a Wrangler front axle, giving more pull from a stop and a higher engine speed at highway pace. The gears need proper mesh, backlash, and pinion depth, so the carrier fit and shim stack matter as much as the gears themselves. Plan a full setup check after installation rather than assuming the first install is right.
Front reverse gears are sensitive to rotation and layout, so confirm the axle type before buying. Tire size shifts the effective gearing, which affects how the new ratio feels on the road. Choose the tire size with the ratio in mind rather than adding the ratio change to a tire change later.
Replacing carrier bearings, pinion bearings, and the pinion seal along with the gears is common practice, since the old parts were worn to the prior pattern. After the break-in miles, check gear oil for fine metal and listen for whine that changes with load.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2051-513R |
| UPC | 631410094589 |
| Axle type | Dana 44 JK |
| Axle location | Front |
| Gear ratio | 5.13 |
| Carrier | For use with 3.73 and down |
| Warranty | 10 years. |
Vehicle fitment
The title places this set on the front Dana 44 axle of the Jeep Wrangler JK, so it covers the JK model years (2007-2018) across its trims. Fitment is based on the product title.
Confirm your vehicle’s year, model and trim before ordering, and check that the axle is the front Dana 44 used in the JK.
Installation notes
A 5.13 front reverse ratio requires careful mesh and preload adjustment, so a shop should do the setup and the first miles should be easy ones.















