Overview
The G2 Dana 44 Rear JK 4.56 Ring and Pinion Set, part number 2-2052-456, is a 4.56-ratio gear set for the rear Dana 44 axle in the Jeep Wrangler JK. It is made for the rear axle position.
G2 says its sets are engineered for the most demanding applications, with the latest technology and materials in the gears.
Key features
- 4.56 gear ratio
- Dana 44 JK rear axle
- Rear axle location
Rear axle wear signs
Rear ring and pinion wear often shows up as a whine that changes with speed or load, or as a clunk when the throttle is applied or released. A ratio of 4.56 is a common choice for trucks that run larger tires and mix trail and highway use, so the gearing affects both engine speed and how the rear end sounds at cruise.
Before replacing gears, inspect the carrier bearings, pinion nut torque, and the fluid for metal particles. Fresh gear oil and a check of the axle breather are simple steps that help the new set last. A rear set is usually installed with new pinion bearings, which keeps the mesh stable over time.
- Listen for whine that changes with load
- Check pinion nut torque on reassembly
- Inspect the fluid for metal particles
- Clear the axle breather
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2052-456 |
| UPC | 631410111132 |
| Axle type | Dana 44 JK |
| Axle location | Rear |
| Gear ratio | 4.56 |
Vehicle fitment
This rear Dana 44 set is for the Jeep Wrangler JK (2007-2018). It covers the JK model years, not a single trim.
Confirm your vehicle’s year, model and trim before ordering, and check that the axle is the rear Dana 44.
Installation notes
The rear 4.56 set needs mesh and preload checked on a setup stand before it is installed, and a short break-in helps it seat.

















