Overview
The G2 Axle and Gear 97-2044-002 is a chromoly Birfield CV style inner axle shaft for the driver side of the front axle on 1975–1984 Toyota Land Cruiser models, including the FJ40.
FJ40 owners use this long driver-side shaft to replace a worn or broken factory inner shaft on the Toyota 9.5 inch front axle. It has 27 splines and measures 28.937 in overall. G2 says its shafts are forged from high grade alloy steel and heat treated for extended service life. Its application note reads: for use in 75-84 Toyota FJ40 Land Cruiser.
The FJ40 front axle is the Toyota 9.5 inch design, so a shaft meant for it has its own length and spline layout. At 28.937 in overall, the driver-side shaft is the long one of the pair, a distinction worth checking when comparing it with the passenger shaft. Chromoly is a chromium and molybdenum alloy steel widely used for strong driveline shafts. G2 does not publish torque or strength figures for this particular part, so expect the benefits to be described by the maker in general terms only.
Key features
- Chromoly inner axle shaft, Birfield CV style
- Driver-side long shaft, front left inner position
- 27 splines
- 28.937 in overall length
- Made for the Toyota 9.5 inch front axle
- Aimed at the FJ40 Land Cruiser
Before you buy
Inner shafts carry drive torque from the differential to the hub, so they see the most stress when the trail gets rough or the front tires are larger than stock. Because a driver-side long shaft and a passenger-side shaft are different parts, confirm which position you are replacing before ordering. Laying the old shaft beside the new one shows whether the length and spline layout match.
Signs of wear include clicking or shuddering on tight turns, vibration under acceleration, and grease on the inside of the wheel. Rounded splines or a twisted shaft means it should not be reused. When the axle is apart, inspect the joint boots as well, since a split boot lets dirt into the joint and speeds up wear.
- Check spline wear on the old shaft and the mating joint
- Inspect the boot and clamp for cracks
- Replace worn hub seals when the axle is opened
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2044-002 |
| UPC | 631410107524 |
| Part type | Inner axle shaft, Birfield CV style |
| Material | Chromoly |
| Axle location | Front |
| Shaft position | Driver side, front left inner |
| Axle type | Toyota 9.5 inches |
| Spline count | 27 splines |
| Overall length | 28.937 in |
| Shaft length | Long axle |
Vehicle fitment
It fits the 1975–1984 Toyota Land Cruiser, with the FJ40 as the specific application.
Land Cruisers built after 1984, including later FJ60 trucks, and all Toyota Pickups are outside this part number, and the passenger-side shaft is separate. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 9.5 inch Toyota axle uses its own shafts, so do not mix this part with components from other Toyota axle sizes. Measure the overall length of your old shaft against 28.937 in and compare spline counts before assembly.










