Overview
The G2 Axle and Gear 95-2025-102 is a one piece replacement axle shaft for the AMC 20 rear axle, made for the passenger side of the 1976–1981 Jeep CJ5, CJ7 and Scrambler. It has 29 splines.
G2 intends the shaft for Jeeps using its one piece axle kit. The company says its shafts are forged from high grade alloy steel and heat treated to exceed OEM specifications for extended service life.
The 95-2025-102 is the passenger-side one piece shaft for the AMC 20 axle, with 29 splines and a vehicle list that names the CJ5, CJ7 and Scrambler. G2 Axle and Gear says its shafts are forged from high grade alloy steel and heat treated to exceed OEM specifications. It is used with the one piece axle kit named in G2’s application.
Key features
- One piece design for the AMC 20 rear axle
- 29 splines
- Passenger-side shaft
- Made for 1976–1981 Jeep CJ5 and CJ7
- Alloy steel forged and heat treated.
- For use with the one piece axle kit
Spline count and gear match
The spline count is the first thing to check on any AMC 20 shaft. The differential gears have to match the shaft, and a shaft with a different count will not seat or turn properly. Use the old shaft as a reference and count the splines on both ends. If the axle has been rebuilt with different gears at some point, verify the count before the shaft goes in.
Because this is a passenger side part, keep the pairing in mind when you service both sides of the axle. The sides are not interchangeable, so mark each shaft as it comes off. Inspect the seal and bearing at the same time, since both are easier to reach once the shaft is out. A worn seal can leak gear oil onto the brake parts, so replace it when the shaft is replaced.
- Count splines on both ends
- Mark each side as it comes off
- Replace the seal with the shaft
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2025-102 |
| UPC | 631410096699 |
| Product type | Replacement axle shaft |
| Axle type | AMC 20 |
| Axle location | Rear |
| Shaft position | Passenger Side |
| Spline count | 29 |
| Stated application | 76-81 Jeep CJ w/One Piece Axle Kit |
Vehicle fitment
It fits the 1976–1981 Jeep CJ5 and CJ7, and the 1981 Jeep Scrambler.
The Scrambler fits 1981 only, and CJ models built after 1981 are not covered. Check year, model and trim against your vehicle before ordering.
Installation notes
- The one piece axle kit is part of G2’s stated application, so confirm your axle is set up for it.
- Match the 29 splines to your differential gears.
What’s included
One passenger-side one piece axle shaft (95-2025-102).
Not included: the axle kit and wheel studs.




