Overview
The G2 Axle and Gear 4-XJ6-410 is a 4.10 ratio front and rear ring and pinion kit for the 1984-2001 Jeep Cherokee (XJ), with a Dana 30 short front and a Chrysler 8.25 rear axle. It includes front and rear gear sets plus matched master installation kits.
The rear axle in this kit is a Chrysler 8.25 rather than a Dana 35. Both ends use the same 4.10 ratio, and the gears suit oversized tires and high performance engines.
Key features
- 4.10 gears front and rear
- Dana 30 short front, Chrysler 8.25 rear
- Matched master installation kits
- Fits 1984 to 2001 XJ Cherokee
- Limited lifetime warranty
Gear swap planning
A gear swap changes the ratio the engine works against, so tire size, transmission and axle choice should be reviewed together. Larger tires already pull the effective ratio down, and a gear set at this ratio can help restore low end pull. Carrier type, locker choice and axle shafts also affect the job, and they are often replaced at the same time as the gears.
The gear set is only part of the job. Pinion depth, preload and backlash must be set on both axles, and the new gears should be broken in gently before heavy towing or hard use. Check the fill level and cover seal after the first drive, and inspect the bearings and seals while the axle is open. Changing the gear oil at the same time keeps fresh lubricant on the new teeth.
- Check the carrier type before ordering
- Inspect axle bearings and seals during the swap
- Use gear oil suited to the gear set
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-XJ6-410 |
| UPC | 700007521861 |
| Product type | Front and rear ring and pinion sets with master installation kits |
| Gear ratio | 4.10 |
| Front axle gears | Dana 30 Short 4.10 |
| Front carrier | 3.73 and up |
| Rear axle gears | Chrysler 8.25in 4.10 |
| Installation kits | Front and rear matched master installation kits |
| Material | Computer heat treated 8620 steel |
| Manufacturing | Manufactured to O.E. specs, double shot peened, double lapped |
| Warranty | Limited lifetime warranty |
Vehicle fitment
The 4-XJ6-410 fits the 1984 to 2001 XJ Cherokee with a Dana 30 short front axle and a Chrysler 8.25 rear axle.
The 4-XJ6-410 does not cover an XJ with a Dana 35 or Dana 44 rear, or another Jeep model. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, preload and backlash must be set on both axles using the master installation kits. The front carrier should be 3.73 and up. A trained installer normally handles this swap.
What’s included
- Front ring and pinion gear set
- Rear ring and pinion gear set
- Front matched master installation kit
- Rear matched master installation kit
Not included: carriers and any parts beyond the master installation kits.









