Overview
The G2 Axle and Gear 4-TJ2-410 is a 4.10 ratio front and rear ring and pinion kit for non-Rubicon Jeep Wrangler TJ models. The TJ chassis code covers the 1997-2006 Wrangler and the set uses a Dana 30 front axle and a Dana 44 rear axle.
The 4.10 ratio is set in both the front and the rear, and the kit supplies the two gear sets together. Matched master installation kits for each axle are included, so both carriers can be set up from one package.
Key features
- Front and rear 4.10 ratio ring and pinion sets
- Dana 30 front axle and Dana 44 rear axle
- Master installation kits matched to each gear set
- Computer heat treated 8620 steel
- Manufactured to original equipment specifications
Setup checks for TJ gearing
A TJ with a 4.10 ratio on both axles turns the engine faster at highway speed than stock, which is a common reason to check transmission and transfer case behavior after the change. Gearing like this often suits trail work and larger tires, though highway driving becomes more engine-driven.
The two master installation kits are matched to their gear sets, so keep each one with its own axle during the rebuild. Check the front carrier type against the Dana 30 setup before installation, then set pinion depth and backlash on both differentials. A tooth contact check helps confirm the setup before the housings are closed.
- Confirm the front carrier type before fitting gears
- Set pinion depth and backlash on both axles
- Check the tooth contact pattern after assembly
- Replace seals and gaskets while the housings are open
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-TJ2-410 |
| UPC | 700007521911 |
| Gear ratio | 4.10 |
| Front axle | Dana 30 TJ |
| Rear axle | Dana 44 |
| Material | Computer heat treated 8620 steel |
| Models | Non-Rubicon |
| Warranty | Limited lifetime |
Vehicle fitment
The kit fits the Jeep Wrangler (TJ) from 1997 to 2006 and is made for non-Rubicon models with a Dana 30 front and Dana 44 rear.
The TJ years run 1997 to 2006, so YJ, LJ and JK Wranglers fall outside that range. Rubicon models are not part of this non-Rubicon set. Verify your year, model and trim before placing the order.
Installation notes
Confirm the front carrier is the Dana 30 type that this set is made for, then set pinion depth and backlash once the gears are installed. Keep each master installation kit with its matching gear set.
What’s included
Front and rear 4.10 ring and pinion sets, plus matched front and rear master installation kits.
Not included: The carriers are sold separately.

















