Overview
The G2 Axle and Gear 2-2080-513 is a 5.13 ratio ring and pinion for the rear Dana 80 axle. The pinion turns 5.13 times for every ring gear revolution, a steep ratio that multiplies torque at the wheels and favors acceleration and low-speed pulling.
G2’s Performance line is designed for oversized tires and high-performance engines, using current materials and manufacturing methods. This 5.13 set is made for the rear Dana 80 axle. Verify the housing and carrier on your vehicle before purchase.
Key features
- 5.13 gear ratio for the Dana 80 rear axle
- Rear axle location
- Ring gear and pinion supplied as a matched set
- Designed for oversized tires and high-performance engines.
- Made with current technology and materials.
Steep ratios and daily use
A 5.13 ratio is one of the steeper choices for this axle. It multiplies torque at the wheels, which helps with starting heavy loads and crawling over obstacles. The tradeoff is that the engine turns faster at highway speed, which can mean more heat and noise on long drives. A steep ratio suits a truck that spends time off road more than one used mostly for long highway trips.
Tire size and gearing work together. Larger tires already reduce the effective ratio, so a steep gear set can restore some of that lost pulling power. When changing tires and gears together, check speedometer accuracy and confirm the drivetrain still runs smoothly under load.
Gear sets wear best when pinion depth, backlash and carrier preload are set correctly. Watch for whine that changes with load, metal in the differential fluid and uneven tooth wear. Replacing carrier bearings and seals during the same job keeps the rebuild consistent and avoids reopening the axle soon after.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2080-513 |
| UPC | 631410094749 |
| Axle type | Dana 80 |
| Axle location | Rear |
| Gear ratio | 5.13 |
| Axle manufacturer | Dana |
Vehicle fitment
This 5.13 set is made for the rear Dana 80 axle. Confirm that housing and carrier on your vehicle before ordering, along with your vehicle’s year, model and trim.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A 5.13 set needs measured pinion depth and carrier preload, so most installers hand the work to a gear shop. A break-in run is needed before heavy use.
What’s included
One 5.13 ring and pinion set for the rear Dana 80 axle, part number 2-2080-513.
Not included: Carrier bearings and shims.
















