Overview
The G2 Axle and Gear 2-2088-410 is a 4.10 ratio ring and pinion for the Ford 8.8 inch front axle. It is made for front axle use only and works with all ratio carriers.
G2 describes these ring and pinion sets as engineered for oversized tires and high performance engines. This set is made from computer heat treated 8620 steel with double shot peened and double lapped surfaces.
Key features
- 4.10 ratio front ring and pinion
- Ford 8.8 inch axle
- Front axle use only
- Works with all ratio carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
Front axle gear service
A front axle ring and pinion carries drive torque only when the front axle is engaged, so its wear pattern can differ from the rear gears. Front gears often see more load during tight turns and low-speed work, where the wheels turn at different rates. Keeping the front differential fluid fresh and checking for play in the front hubs helps protect a new set during everyday use.
Front gears are usually replaced with carrier bearings and the pinion seal, since those parts set the preload and mesh the new gears rely on. Break in the new set gently and check the front axle for leaks after the first trips. If the teeth show chips, pitting or polished spots, or if the axle whines in a way that changes with speed, the set may be worn.
- Check front differential fluid after break-in
- Inspect the front pinion seal for leaks
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2088-410 |
| UPC | 631410105391 |
| Gear ratio | 4.10 |
| Axle location | Front |
| Axle type | Ford 8.8 inch |
| Popular axle manufacturer | Ford |
| Carrier requirement | All ratio carriers |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It fits the Ford 8.8 inch front axle at a 4.10 ratio.
It is made for the front 8.8 inch axle, not the rear. Match the year, model and trim of your vehicle before ordering.
Installation notes
Front gears need pinion depth, backlash and bearing preload set by a driveline shop, followed by a break-in period on the 4.10 ratio.
What’s included
A matched ring and pinion for the Ford 8.8 inch front axle.














