Overview
The G2 2-2081-457 is a 4.57 ratio ring and pinion for Suzuki axles. It covers the Suzuki 10 Bolt and Suzuki 6.875 inch axle types. The pinion turns 4.57 times for each full turn of the ring gear, a numerically high ratio that favors low-speed pulling force over highway rpm.
G2’s Performance Ring and Pinion range is built for oversized tires and high-performance engines, using current materials and manufacturing methods. The axle type and ring gear size on your vehicle are the key checks before buying. This set is made for Suzuki 10 Bolt or 6.875 inch axles.
Key features
- 4.57 gear ratio for Suzuki axles
- Suzuki 10 Bolt and Suzuki 6.875 inch axle types listed
- Front or rear axle location.
- Ring gear and pinion supplied as one set
- Designed for oversized tires and high-performance engines.
Suzuki axles and low-speed work
Suzuki axles like the 10 Bolt and 6.875 inch units are common on light off-road builds, where low-speed control matters more than top speed. A 4.57 ratio gives the pinion more turns per wheel rotation, which helps climbing and crawling. The trade-off is higher engine rpm at highway speed, so the ratio suits trails more than long highway commutes.
Before changing gears, measure the ring gear diameter and identify the housing by its casting marks. Check the pinion flange and carrier bearing caps to confirm the unit matches the set. Small differences in housing design can change which carrier parts and shims are needed, so confirm them before the axle is opened.
Gear sets on older axles often benefit from fresh pinion and carrier bearings and new seals. Inspect the axle shafts and the differential fluid after installation, and listen for whine under light load, which can signal a setup issue that is worth correcting early.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2081-457 |
| UPC | 631410112665 |
| Axle type | Suzuki 10 Bolt or Suzuki 6.875 Inches |
| Axle location | Front or rear |
| Gear ratio | 4.57 |
| Axle manufacturer | Other |
Vehicle fitment
This 4.57 set is made for Suzuki 10 Bolt or Suzuki 6.875 inch axles. Match it to your axle type and ring gear size, and confirm fit for your vehicle’s year, model and trim before ordering. If your housing is a different unit, this set is not the right part.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and carrier preload must be set with measuring tools, so most owners use a gear shop. Allow a break-in period before heavy loads.
What’s included
One 4.57 ring and pinion set for Suzuki axles, part number 2-2081-457.
Not included: Carrier bearings and shims.
















