Overview
The G2 Axle and Gear 1-2017-410 is a 4.10 ratio O.E.M. series ring and pinion for the GM 10 bolt 8.0 inch IFS axle. It is made for both front and rear locations.
The O.E.M. series in this 4.10 set runs cooler and quieter than aftermarket gears. The gears are made under contract with original equipment manufacturers, and the 4.10 ratio is made for the 8.0 inch IFS housing type.
Key features
- O.E.M. series 4.10 ring and pinion
- GM 10 bolt 8.0 inch IFS axle type
- Front and rear locations listed
- Built under contract with original equipment manufacturers.
- Designed to run cooler and quieter than aftermarket gears.
Front and rear use
A 4.10 ratio can be used in either the front or rear position on this axle type, so the setup should be matched to the location. Front axles on an independent suspension carry drive, steering and load forces, which means the pinion and carrier work hard under throttle. Choose the position first and confirm the ratio suits the vehicle’s tire size.
Independent front axles also need careful attention to carrier bearings, axle shafts and pinion angle. Worn joints or shafts can shift the tooth pattern and cause noise. Check for play and leaks at each service, and avoid mixing gears from different ratios or axle types.
- Confirm the axle position before installing
- Check axle shaft joints for wear
- Verify pinion angle after gear work
- Keep gear oil at the correct level
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 1-2017-410 |
| UPC | 631410092783 |
| Gear ratio | 4.10 |
| Axle location | Front and rear |
| Axle type | GM 10 bolt 8.0 inch |
| Popular axle manufacturer | GM |
| Series | O.E.M. |
Vehicle fitment
This 4.10 set is made for the GM 10 bolt 8.0 inch IFS at a 4.10 ratio. Confirm the housing before ordering.
Only the GM 10 bolt 8.0 inch is named for this 4.10 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and bearing preload on the 8.0 inch 4.10 gears should be set by a driveline shop, followed by a break-in period.
What’s included
A matched O.E.M. series ring and pinion for the GM 10 bolt 8.0 inch axle type.
















