Overview
The G2 Axle and Gear 25-2021F is a minor ring and pinion installation kit for the GM 10 Bolt 8.5 Inches front axle.
Front-axle installs on the GM 10 bolt 8.5 inch design use the 25-2021F, the front version of G2’s minor kit. It contains a shim kit, pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and marking compound.
G2 gives the front 8.5 inch axle its own part number, 25-2021F, even though it shares the axle size with the rear kit. The contents are the same family of parts: a proper shim kit, nut, crush sleeve and seal, ring gear bolts, silicone sealer, Loctite and gear marking compound. Check the axle location before choosing, since a rear kit is not the right number for a front axle.
Key features
- Minor kit for the GM 10 Bolt 8.5 Inches axle (front)
- Meant for jobs that keep the existing bearings
- Shim kit for setting pinion depth and carrier position
- Pinion nut, crush sleeve and pinion seal
- Ring gear bolts and silicone sealer
- Loctite and gear marking compound
Front axle installation tips
Front axles carry steering loads and often take harder use off-road, so the carrier and pinion bearings deserve a close look before the gear set goes back in. Front differentials on many trucks sit closer to the ground, which makes clean seals and the correct gear oil level especially important. Plan the job with the axle fully drained and cleaned.
Set pinion depth with the shims before final preload, then check the pattern on both drive and coast sides. Because front and rear kits share the same axle size, label the parts as you remove them so the shims and bearings return to the correct axle. Use new seals and gaskets wherever a sealing surface is opened.
- Drain and clean the housing before starting
- Check the front pinion bearing for roughness
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2021F |
| UPC | 631410094930 |
| Kit type | Minor kit |
| Axle location | Front |
| Axle type | GM 10 Bolt 8.5 Inches |
| Axle manufacturer | GM |
| Manufacturer part number | G/225-2021F |
Vehicle fitment
It is the front version for the GM 10 bolt 8.5 inch axle. The rear-axle match is 25-2021. Match the axle type and year before you order.
Confirm your vehicle’s axle type and year before ordering.
Installation notes
Confirm the location before you order, since front and rear carry different part numbers. Bearings are reused, so inspect them closely and set depth with the shims.
Before starting the 25-2021F job on the GM 10 Bolt 8.5 Inches axle, gather a dial indicator, a torque wrench and clean gear oil. Note the old pattern on the teeth, because the shims in the 25-2021F are the means of correcting the new one. The old nut and seal are replaced. Keep races paired with bearings.
What’s included
- Proper shim kit
- Pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite thread locker
- Gear marking compound
Not included: bearings and gears; the 25-2021F is a minor kit for the GM 10 Bolt 8.5 Inches axle.







