Overview
The G2 Axle and Gear 96-2025-3 is an AMC 20 rear chromoly one-piece axle kit with 29 splines and a 5-lug pattern for 1982-1986 Wide Track Jeep CJ7 models.
G2 Axle and Gear says its axle kits are made from high-tensile alloy steels that are forged and heat treated for strength, and that the larger diameter of Big Spline shafts lets them withstand much higher torsional loads than the stock diameter, so the axle shafts stop being the weakest point of the driveline. With 29 splines, the 96-2025-3 only engages gears cut for 29 splines, so check the differential before choosing it.
Key features
- Rear axle kit for the AMC 20
- 29 spline, 5-lug, one-piece axle design
- Includes wheel bearings
- Includes wheel studs
- Includes retainer plates with seals
- Made from high tensile alloy steel, forged and heat treated
- Fits Wide Track CJ7 and CJ8 models only
Before installing the axles
A one-piece axle replaces the shaft, bearing and retainer as one assembly, so the old components should come off together. Clean the hub and axle tube before fitting the new parts, and check the seal surfaces for scoring. Clean threads and correct bearing seating make a noticeable difference to how quiet the hub runs.
Work through the differential before the axles go in. The carrier bearings, pinion seal and ring-and-pinion gears should be inspected for wear, because new shafts will load worn gears just as hard. Check that the gear set matches the spline count of the new axles, and keep the axle ends clean while assembling.
- Replace the old shafts and bearings as a set
- Inspect the retainer seals for nicks
- Confirm the gear set spline count before assembly
- Torque the wheel studs after the first drive
Specifications
The 96-2025-3 is a rear one-piece axle kit for the AMC 20 rear axle, with 29 splines. Every figure in the table below is the manufacturer value for the 96-2025-3.
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 96-2025-3 |
| UPC | 631410096873 |
| Part type | Rear one-piece axle kit |
| Axle | AMC 20 rear |
| Spline | 29 spline |
| Lug pattern | 5-lug |
| Construction | 1-piece axle kit |
| Differential | None included |
| Application stated | 82-86 Wide Track CJ7 and CJ8 only |
Vehicle fitment
It fits 1982-1986 Wide Track CJ7 models, and the CJ8 is covered by the same application.
The 96-2025-3 is for 82-86 Wide Track CJ7 and CJ8 models only.
Measure the shaft you are replacing and compare it with the 96-2025-3 listing for spline count, length and side.
Only Wide Track applications are covered, so Narrow Track and Quadratrac CJ axles are outside this kit. Check your axle’s track width before ordering.
Installation notes
The kit is for the Wide Track CJ7 and CJ8 only. Because it is a one-piece axle kit with wheel studs, bearings and retainer plates with seals, the original shafts and bearings are replaced as a set.
What’s included
- Wheel bearings
- Wheel studs
- Retainer plates with seals
- One-piece axle shafts










