Overview
The 95-2052-2-322 is a passenger-side rear axle shaft for the Dana 44 rear axle, made for the 2007–2009 Jeep Wrangler JK Rubicon. It replaces the factory shaft with a forged alloy steel unit that has a 32-spline end and is built for high-torque driving.
The shaft is heat treated beyond OEM specifications and built to carry the added load of larger tires. It is a rear, passenger-side part only: the driver-side shaft is a separate part, and wheel studs are not included, so plan for them if your hub needs them.
Key features
- Forged from high-grade alloy steel
- Heat treated to exceed OEM specifications
- 32-spline axle shaft end for the Dana 44 rear differential
- Rolled splines and upgraded materials, as G2 describes for its Dana 44 shaft line
- Designed for larger tires and high-torque use
Trail use and tire load
Rear axle shafts on a Dana 44 carry the full torque of the drivetrain to the wheel, and they take the most strain when the tires are larger than stock. Each shaft works with the axle bearing, the seal and the differential carrier, so a shaft problem often shows up as a bearing or seal leak. Before ordering, check the shaft side and the 32-spline end against the existing hardware, since a mismatched side will not install correctly.
Off-road use adds sudden load from rock crawling and wheel hop. Look for grease in the brake area, a vibration that changes with speed, or a clicking noise from the rear, since these can point to a worn shaft or loose hardware. Replacing the wheel studs at the same time keeps the hub secure when the shaft comes out, and a quick torque check after the first few trail runs is good practice.
- Check side and spline count before ordering
- Inspect the bearing and seal during install
- Re-check wheel nuts after early trail runs
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2052-2-322 |
| UPC | 631410106480 |
| Axle type | Dana 44 JK |
| Axle location | Rear |
| Shaft side | Passenger side |
| Spline count | 32 splines |
| Material | High-grade alloy steel, heat treated |
| Wheel studs | Not included |
Vehicle fitment
It fits 2007–2009 Jeep Wrangler JK models, including the Rubicon and Unlimited Rubicon, on the Dana 44 rear axle. Match the model years first, since those are the years it is made for.
Wrangler TJ, LJ and JL models are not covered, and the driver-side shaft is a different part. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One passenger-side rear axle shaft with a 32-spline end.
Not included: Wheel studs.







