Overview
It is a passenger-side inner axle shaft for the Dana 44 JK front axle, fitting 2007–2012 Jeep Wrangler JK models.
The shaft keeps the stock overall length and has a 30-spline end, so it is a like-for-like swap. It is forged from high-grade alloy steel and heat treated to exceed OEM specifications, and it accepts a 5-7166X U-joint.
Key features
- Passenger-side inner shaft for the Dana 44 JK front axle
- Stock overall length
- 30-spline shaft end
- Accepts a 5-7166X U-joint
- Machined for full circle clips
Inner shaft install checks
An inner axle shaft on a Dana 44 front axle carries drive torque from the differential to the front hub. Because the shaft keeps the stock overall length, it should fit without changing the axle geometry. Measure the old shaft from the splined end to the U-joint end and compare it with the new one. Check the U-joint and retainer as well, since the joint carries the angle of the front suspension.
Front axle work often reveals other wear. Inspect the axle seal, the U-joint caps and the retainer for grease leakage or looseness. Clean the spline ends and apply fresh grease before installation. Once the shaft is in, cycle the steering through its full travel and listen for clicks or binding. If the joint feels loose, check the bolts before the vehicle is driven.
- Measure overall length before removal
- Inspect the U-joint and retainer
- Cycle steering to check for binding
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2051-003 |
| UPC | 631410097405 |
| Axle type | Dana 44 JK |
| Axle location | Front |
| Shaft position | Passenger side, inner |
| Overall length | Stock |
| Spline count | 30 splines |
| U-joint | Accepts 5-7166X |
| Retainer | Machined for full circle clips |
Vehicle fitment
It fits 2007–2012 Jeep Wrangler (JK) models on the Dana 44 front axle.
The driver-side outer for the JK is 97-2051-001. Wrangler TJ, LJ and JL models are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the shaft keeps the stock overall length, the existing length measurement should match your front axle. Confirm the U-joint and retainer as well before installing.
What’s included
One passenger-side inner axle shaft.







