Overview
The G2 Placer Gold Series Dana 44 JK Rear Axle Shaft, part 195-2052-1, is a single rear axle shaft for the Jeep Wrangler JK, 2007 to 2018, two-door and four-door. It is sold for the driver or passenger side.
The shaft is for a Dana 44 rear axle on non-Rubicon models and is intended for use with 30 spline aftermarket lockers. It is forged from 4340 chromoly steel with a stronger forging and more material in critical areas.
Key features
- Forged from 4340 chromoly steel
- Stronger forging with extra material in critical areas
- Dual bolt pattern flange, 5×5 and 5×5.5
- 30 spline
- Made in the USA
Matching the axle and locker
The 30 spline end has to match the locker or spool that goes into the Dana 44 housing, so the spline count is the first check before any other work. Aftermarket lockers and axle shafts are often sold as matched sets, and mixing a shaft from one maker with a locker from another can leave the spline fit loose or binding.
Shafts wear at the splines and at the bearing seat over time. Look for rust, twisting marks or chipped splines when the axle is apart, and check the wheel studs and bearing for play. Replacing a shaft alongside the seal and bearing is common practice, since the work is much the same once the housing cover is open. Keep track of the driver and passenger positions when removing the old shaft, and keep the new shaft clean and lightly oiled before installing it.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 195-2052-1 |
| UPC | 631410118735 |
| Axle | Rear Dana 44 |
| Spline count | 30 |
| Flange | Dual bolt pattern, 5×5 and 5×5.5 |
| Side | Driver or passenger |
| Material | 4340 chromoly steel |
Vehicle fitment
This rear axle shaft is for the Jeep Wrangler JK, 2007 to 2018, with a Dana 44 rear axle, in two-door and four-door models.
Other Wrangler generations and the Gladiator are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pick the side you need before ordering, since the shaft is sold for either the driver or passenger position, and the 30 spline end must match the locker.
What’s included
One rear axle shaft, driver or passenger side per order.











