Overview
The Fabtech FTS22182 is a bolt-on front upper Uniball control arm kit for the 2015–2017 Ford F-150. It comes with two stainless steel taper Uniball pins, a complete bushing set, four 17-4 stainless steel misalignment spacers and a complete installation hardware pack.
The parts listed above make up the full kit.
Key features
- Bolt-on installation
- Two stainless steel taper Uniball pins
- Complete bushing set
- Four 17-4 stainless steel misalignment spacers
- Complete installation hardware pack
Bolt-on upper arm install
A bolt-on upper arm replaces the factory arm using the same mounting points, which keeps the job to removal and fitting. Before you begin, support the vehicle safely, label the hardware as it comes off, and clean the mounting surfaces. Dry-fitting the pins and bushings helps you spot any misfit before the arms are fully torqued.
Misalignment spacers help set the arm’s position at the frame, and they should sit square with no binding. Uniball pins seat in the spindle taper, so clean the taper before pressing the pin in. After the arms are on, caster and camber shift, so an alignment is part of finishing the install.
- Label hardware during removal
- Clean the spindle taper before fitting pins
- Check spacer orientation before torquing
- Schedule an alignment after installation
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTS22182 |
| UPC | 674866090767 |
| Position | Front upper |
| Joint pins | Two stainless steel taper Uniball pins |
| Spacers | Four 17-4 stainless steel misalignment spacers |
| Bushings | Complete set |
| Hardware | Complete installation hardware pack |
| Installation | Bolt-on |
Vehicle fitment
The manufacturer fitment list gives 2015–2017 Ford F-150 in King Ranch, Lariat, Limited, Platinum, SSV, XL and XLT trims.
Ford F-150 years outside 2015–2017 and other Ford models are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is a bolt-on kit that does not require drilling or welding. Have the alignment checked once the arms are on.
What’s included
Two stainless steel taper Uniball pins, a complete bushing set, four 17-4 stainless steel misalignment spacers and a complete installation hardware pack.
Not included: Check the box on arrival to confirm the control arm bodies are included.









