Overview
The Omix-Ada Rear Lower Control Arm, part number 18282.06, is a direct replacement rear lower control arm for the 1993–1998 Jeep Grand Cherokee (ZJ). It includes its bushing, and Omix-Ada builds it to original specifications.
Omix-Ada provides a limited five year warranty on the arm. The arm is for the rear lower position.
Key features
- Direct OE replacement built to original specifications
- Includes bushing
- Rear lower position
- Limited five year warranty
Lower arm bushing check
Rear lower control arms carry axle loads under braking and acceleration, and they hold the axle in its fore and aft position as the suspension moves. Their bushings take repeated stress at both ends, so rubber can crack, harden, or soften with age. Once the bushing wears, the axle can shift, which may show up as a clunk over bumps, rear end wander, or uneven tire wear. Trail use adds more articulation load, so inspect the bushing more often on a vehicle that sees rough terrain.
When fitting a new lower arm, check the frame and axle mounting points for corrosion and confirm the bolts are clean and free of damage. Seat the bushing squarely and avoid pinching it during assembly. Tighten the fasteners to the factory torque setting, and have the rear alignment checked afterward, since lower arm changes affect axle angle. Recheck the bolts after the first few drives.
- Cracked or hardened bushing
- Corrosion at frame mount
- Bent arm after an impact
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18282.06 |
| UPC | 804314053338 |
| Position | Rear Lower |
| Included | Bushing |
| Fit type | Direct fit |
| Warranty | Limited five year warranty |
Vehicle fitment
The arm is for the 1993–1998 Jeep Grand Cherokee ZJ in 5.9 Limited, Base, Laredo, Limited, Orvis, SE and TSi trims.
This arm is designed for ZJ Grand Cherokee applications. Confirm fit for your vehicle’s year, model and trim before ordering.
What’s included
The arm comes with its bushing. No other hardware is described.









