Overview
The Fabtech K3068 is a 5-inch radius arm lift for the 2014–2018 Ram 2500. It replaces the front suspension arms with tubular radius arms that use dimple die side plates for strength. The new arms add caster, which helps with oversized tires and higher lift heights.
The stock front coil springs are mounted with angular steel spacers to keep the factory spring bow, which supports the alignment and ride quality the factory designed. Flat spacers do not preserve that bow. The rear coil springs are kept with steel spacers so the weight carrying capacity is unchanged. Heavy duty 1/4-inch thick steel front and rear track bar drop brackets center the axles at the new ride height, and steel front bump extensions replace urethane extensions, which can blow out under hard use.
Key features
- 5-inch lift, range 5 to 6.99 inches
- Tubular radius arms with dimple die side plates
- Increased caster for oversized tires
- Angular steel spacers that keep the factory spring bow
- Steel rear spacers that keep the weight carrying capacity
- Steel front bump extensions
Ram 2500 ride height and steering
Radius arms change the front axle’s fore and aft position, so they carry braking and drive forces through their bushings and mounts. Check the bushings after the first few drives and whenever the front end is serviced. Caster is set by the arm geometry, so steering feel will change after installation, which is normal for a lift of this type.
Track bar drop brackets set the lateral position of the axle at the new height, and a worn track bar or drop bracket shows up as wandering or a loose steering feel. Steel bump extensions handle compression at full travel, so check their mounts and the shock mounts for cracks. Re-tighten fasteners after the first trail runs.
- Inspect radius arm bushings
- Check track bar and drop bracket bolts
- Look for cracks at shock mounts
- Recheck alignment after the first few weeks
Specifications
| Brand | Fabtech |
|---|---|
| Part number | K3068 |
| UPC | 700007027871 |
| Lift height | 5 inches (range 5 to 6.99 inches) |
| Suspension type | Spacer, radius arm |
| Front spring spacers | Angular steel |
| Rear spring spacers | Steel |
| Track bar drop brackets | 1/4-inch thick steel, front and rear |
| Tire and wheel fit | 37×12.50R17 on 17×9, 37×12.50R18 on 18×9, 37×13.50R20 on 20×9.5, 37×13.50R22 on 22×9.5; 5-inch backspacing |
| Shocks | Front and rear performance shocks, included |
Vehicle fitment
It fits the 2014–2018 Ram 2500, including Big Horn, Laramie, Laramie Limited, Laramie Longhorn, Limited, Lone Star, Outdoorsman, Power Wagon, SLT and Tradesman models.
The list covers the Ram 2500 in 2014 through 2018 only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Each tire and wheel combination needs minor trimming. The steel front bump extensions are part of the kit and replace the urethane extensions.
What’s included
Tubular radius arms with dimple die side plates, angular steel front spring spacers, steel rear spacers, front and rear track bar drop brackets, steel front bump extensions and front and rear performance shocks.









