Overview
The Dana Spicer 10015183 is a front outer replacement axle shaft for Dana Super 30, Dana 44 and Ultimate Dana 44 front axles. It is 6.33 inch long, has 32 splines and is made from SAE-4340 nickel chromoly steel. It fits the 2007–2018 Jeep Wrangler (JK).
Dana Spicer says chromoly shafts like this one are engineered for strength and durability in off-road use. The steel gives extra toughness, high-temperature strength and abrasion resistance. The shaft is an outer stub, so it is fitted at the wheel end of the front axle.
Key features
- Front outer position, outer stub
- Length 6.33 inch
- 32 splines
- SAE-4340 nickel chromoly steel
- Fits Dana Super 30, Dana 44 and Ultimate Dana 44 front axles
Outer stub and U-joint service
The outer stub connects the axle shaft to the hub or wheel end, and it carries drive torque to the tire. The U-joint at the shaft end allows the angle change as the suspension moves. A worn U-joint can make a clunk on acceleration or a vibration at speed, and it often wears faster on vehicles that run large tires or hard trail use.
Before fitting a new outer shaft, inspect the spline ends and the hub face for wear, and clean any rust or debris from the mating surfaces. Use fasteners that match the axle type, and check the U-joint for smooth movement with no play. Because the joint is a wear item, replacing it together with the shaft during a repair is common practice.
- Inspect the U-joint caps for play
- Clean the spline and hub mating surfaces
- Check the boot or seal for damage
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 10015183 |
| Axle type | Dana 30/44, Super 30, Dana 44 or Ultimate Dana 44 |
| Axle location | Front |
| Position | Front outer |
| Shaft location | Outer stub |
| Length | 6.33 inch |
| Spline count | 32 |
| Material | SAE-4340 nickel chromoly |
| U-joint required | 5-7166X |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler (JK), in two-door and four-door models. The Wrangler JL is outside its fit. Match the year, model and trim to your vehicle first.
It goes in the front outer position only, so check the axle type and the side before buying.
Installation notes
A 5-7166X U-joint is required with this shaft, so order it with the shaft. Confirm the front axle is a Dana Super 30, Dana 44 or Ultimate Dana 44 before fitting.
What’s included
One front outer axle shaft. Order the 5-7166X U-joint separately, since it is required with this shaft.









