Overview
The Crown Automotive 52060053AE is a driver side tie rod to knuckle end, 11 inches long, for 2 and 4-door models. It is a replacement steering part for Jeep vehicles.
The UPC is 848399038682. Measure and compare the length and mounting with your original part before ordering.
Key features
- Driver side tie rod to knuckle end
- 11 inches long
- Fits 2 and 4-door Jeep models
- Single piece, not a kit
Measuring before you swap
A tie rod to knuckle end sets the wheel’s toe and carries steering motion from the linkage to the spindle, so its overall length and ball joint position matter as much as the thread. Measuring the original end from center to center before removing it gives a useful baseline. The jam nut and sleeve setting also determine how much adjustment is left after installation.
Driver and passenger ends are separate parts, so confirm the side before ordering. Inspect the knuckle taper and the castle nut for wear when the old end comes off, and replace any worn cotter hardware. Once the new end is installed, toe should be set and the steering centered before the vehicle is driven.
- Measure center to center before removal
- Confirm the driver side before ordering
- Replace worn cotter hardware
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52060053AE |
| UPC | 848399038682 |
| Side | Driver |
| Mounts | Tie rod to knuckle |
| Length | 11 inches |
| Body style | 2 and 4-door models |
| Quantity | Single piece |
Vehicle fitment
It fits 2 and 4-door models, which does not identify a specific Jeep generation. Check the length and mounting against your original end.
The passenger side end is a different part and is not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Measure the original end’s overall length first, since this one is 11 inches. Confirm the jam nut and cotter pin before installing.
What’s included
One driver side tie rod to knuckle end. Not included: the jam nut and cotter pin.









