Overview
The Crown Automotive 4801269AB is a replacement starter motor for the 2007–2010 Jeep Wrangler JK with the 3.8L engine and manual transmission. It fits both 2-door and 4-door models. Its torque rating is 100 to 150 ft-lbs.
A starter motor turns the engine over when you engage the ignition, so a failing unit usually shows up as slow cranking or no crank at all. This replacement is tied to one engine and transmission combination, so check your Wrangler against those details before ordering.
Starter diagnosis and wiring
A starter that clicks without turning often has a weak battery, a corroded cable or a loose ground rather than a failed motor. Test battery voltage and clean the terminals before removing anything. If the lights dim sharply on turning the key while the starter only clicks, the starter or its solenoid becomes the more likely cause.
When the starter is out, check the ring gear teeth on the flywheel for wear or chips, since damaged teeth can wear a new starter quickly. Confirm the mounting bolts are tight and the heat shield is in place. Clean the ground strap connections as well, because a poor ground can make a new starter appear to fail.
- Clean battery terminals and cable ends
- Check the ground strap connection
- Inspect the flywheel ring gear teeth
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 4801269AB |
| UPC | 848399085426 |
| Type | Replacement |
| Engine | 3.8L |
| Transmission | Manual |
| Body styles | 2-door and 4-door |
| Torque rating | 100–150 ft-lbs |
Vehicle fitment
It fits the 2007–2010 Jeep Wrangler JK, including Rubicon, Sahara, Sport and Unlimited versions.
Wrangler TJ and LJ models and JK years after 2010 are outside this fit. Verify your year, model and trim against this application before ordering.
Installation notes
This starter is for manual transmission vehicles. Confirm your transmission before fitting it.









