Overview
The Crown Automotive 52008905 is a rear e-brake cable for the driver side of the 1994–1998 Jeep Grand Cherokee (ZJ).
It is a stock length cable, matching the original rear cable length rather than an extended one.
Key features
- Rear left e-brake cable
- Stock length
- Driver side position
- Direct fit for the 1994–1998 Grand Cherokee (ZJ)
Choosing a replacement cable
Stock length means the cable matches the original routing and tension range, which keeps the parking brake lever travel close to factory. An extended cable can leave the rear brake under-tensioned or cause the lever to bottom out before the shoes engage. When choosing a replacement, match the cable to the side and position before comparing lengths, since the driver and passenger cables are not interchangeable.
Check the full path when replacing the cable. Look for a worn guide, a sticking housing or a pinched section, since a new cable will not move properly through a damaged route. Inspect the rubber boot and the cable ends for splits at each service because cracked boots let water and grit into the housing. Keep the cable clear of exhaust heat and sharp edges during reinstallation.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52008905 |
| UPC | 848399014167 |
| Part type | Rear e-brake cable |
| Position | Rear left, driver side |
| Length | Stock |
| Type | Rubber |
| Fit type | Direct fit |
Vehicle fitment
It fits the 1994–1998 Jeep Grand Cherokee (ZJ).
It is for the driver side only, and Grand Cherokee model years outside 1994 to 1998 are not covered. Check the year, model and trim against your vehicle before ordering.









