Overview
The Crown Automotive J0645663 is an oil seal for the steering shaft bellcrank bearing on Jeep vehicles. It fits 1966–1971 Jeep CJ5 (Base), CJ6 (Base) and Commando (Base).
An oil seal keeps lubricant in the bearing area and blocks dirt from entering. Each application needs a set count of seals, so count the seal positions on your steering setup before ordering.
Key features
- Oil seal for the steering shaft bellcrank bearing
- Fits 1966–1971 Jeep CJ5, CJ6 and Commando models
- Two needed per application
- Crown Automotive brand, part number J0645663
Replacing the bellcrank seal
The bellcrank bearing sits in the steering linkage area and depends on grease staying inside. A worn seal lets lubricant escape and lets grit reach the bearing, which can cause rough steering or noise from the linkage. Look for grease streaks, dirt packed around the bearing and play when the bellcrank is moved by hand.
Before fitting a new seal, clean the bore and check the shaft surface for grooves that could cut the lip. A light coat of grease on the lip helps it seat, and a seal driver keeps it square. Replace the bearing too if it feels rough or loose, and inspect both bellcrank positions together.
- Grease streaks around the bearing
- Dirt or moisture packed into the joint
- Rough or notchy steering feel
- Grooves on the shaft surface
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0645663 |
| UPC | 848399052831 |
| Component | Steering shaft bellcrank bearing oil seal |
| Quantity required | Two per application |
| Fitment | Direct fit per manufacturer fitment list |
Vehicle fitment
The manufacturer fitment list for this seal covers the 1966–1971 Jeep CJ5 (Base), CJ6 (Base) and Commando (Base).
Jeep CJ7 and Wrangler models are not on the list for this seal. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Two seals are needed per application, so plan for that quantity before starting.









