Overview
The Crown Automotive J5356183 is a front hub and rotor assembly with a 6 bolt caliper plate for the 1974–1980 International Scout II and the 1977–1978 Jeep CJ5 and CJ7.
Crown Automotive describes itself as a manufacturer and distributor of Jeep replacement parts for more than 50 years, with over 8,000 part numbers that include factory-discontinued items. The J5356183 is a direct-fit front replacement.
Key features
- Hub and rotor assembly in one piece
- 6 bolt caliper plate
- Thick rotor, 1-1/8 inch wide
- Direct-fit front position
Front hub and bearing service
A front hub and rotor assembly carries the wheel bearings, the rotor and the caliper mounting. When the hub is replaced, the bearing preload and seal condition matter as much as the rotor itself. Front hubs take the steering loads and road shocks, so a loose or worn hub often shows up as vibration or a grinding noise during braking.
A new hub assembly is often installed alongside new brake pads, since the friction surfaces on old pads may not match the new rotor face. Check the caliper bracket and bolts for corrosion, and clean the mounting faces so the assembly sits flat. Tighten the wheel studs and recheck them after the first few runs.
- Check the caliper bracket bolts
- Clean the rotor mounting face
- Replace worn pads alongside the hub
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J5356183 |
| UPC | 848399079470 |
| Item type | Hub and rotor assembly with a 6 bolt caliper plate |
| Position | Front |
| Fit | Direct fit |
| Caliper plate | 6 bolt |
| Rotor width | 1-1/8 inch (thick rotor) |
Vehicle fitment
It is a direct fit for the 1974–1980 International Scout II (Base, SS2, Terra, Traveler and XLC) and the 1977–1978 Jeep CJ5 and CJ7, including the Golden Eagle and Renegade versions.
Other CJ5 and CJ7 model years and other International Scout models are not on the list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
- Hub and rotor assembly with a 6 bolt caliper plate









