Overview
The Crown Automotive 68038761AA is a Dana 44 rear 3.73 ratio ring and pinion set for the 2008–2018 Jeep Wrangler (JK), in 2-door and 4-door models. It is a rear-position replacement gear set and a direct fit.
The set includes ring gear bolts, a crush sleeve, a pinion washer and a pinion nut.
Replacing a rear ring and pinion on a Wrangler JK with a Dana 44 axle is usually part of a re-gearing job after a tire size change. The 68038761AA is a direct fit for the rear Dana 44, and 3.73 is the ratio for this part number.
Key features
- Dana 44 rear axle ring and pinion set
- 3.73 gear ratio
- Includes ring gear bolts, crush sleeve, pinion washer and pinion nut
- Covers 2-door and 4-door models
- Fits 2008–2018 Jeep Wrangler (JK)
Gearing and tire size
A 3.73 ratio changes how the engine turns the tires at a given speed. Owners often choose a ratio like this after moving to larger tires, since the change restores low-speed pull and keeps the engine in a useful range. The ratio is only part of the decision. Tire diameter, transmission gearing and how the vehicle is used off road all shape whether a particular ratio suits a build.
A ring and pinion swap is precise work. Pinion depth, backlash and contact pattern must be set correctly, and the crush sleeve is a one-time part that must be replaced rather than reused. Carrier bearings and the axle cover gasket are often replaced at the same time. Check speedometer accuracy after the change, since speed and odometer readings will shift with the new ratio.
- Confirm tire size before choosing a ratio
- Replace the crush sleeve every time
- Check speedometer accuracy after the change
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 68038761AA |
| UPC | 849603002703 |
| Axle | Dana 44 |
| Axle position | Rear |
| Gear ratio | 3.73 |
| Body styles | 2 and 4-door models |
| Fit type | Direct Fit (per Crown) |
Not stated by the manufacturer: the tooth counts, the material and whether carrier bearings or a shim kit are included.
Vehicle fitment
It fits the 2008–2018 Wrangler JK. Because it is specific to the rear Dana 44 axle, fit applies to the whole model and years rather than individual trims.
The manufacturer fitment list for part 68038761AA covers: 2008–2018 Jeep Wrangler (JK).
Not listed: the 2007 Wrangler (JK), the Wrangler (JL) and earlier Wrangler generations (TJ, YJ), and any JK front axle. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A new ring and pinion needs the pinion depth and backlash set and the contact pattern checked. The crush sleeve in the kit is a one-time-use item that sets pinion bearing preload during assembly, so the job is usually left to a shop with the right tools.
What’s included
- Ring and pinion gear set, 3.73 ratio
- Ring gear bolts
- Crush sleeve
- Pinion washer
- Pinion nut
Not included: Differential carrier, bearings and shim kit are not part of this kit.









