Overview
The G2 Axle and Gear 1-2094-342 is a 3.42 ratio O.E.M. series ring and pinion for the GM 7.25 inch IFS front axle. It fits the front location with a universal fit by axle type.
Gears in this O.E.M. line run cooler and quieter than aftermarket options, and they are made under contract with original equipment manufacturers. A 3.42 ratio gives less torque multiplication at the wheels than a 3.73 set.
Key features
- O.E.M. series 3.42 ring and pinion
- GM 7.25 inch IFS front axle type
- Front axle location
- Made under contract with original equipment manufacturers.
- Runs cooler and quieter than aftermarket gears.
Front axle setup notes
The 7.25 inch IFS housing carries the front ring and pinion in a compact carrier, and the front position brings steering and braking loads into the gear mesh. Choosing a 3.42 ratio means matching the front to the rest of the drivetrain, including the transfer case and rear gears, so the vehicle does not feel mismatched when the front wheels engage. Measure the tire diameter before choosing and keep it consistent across all four corners.
Front axle work is often more crowded than rear work, so plan for good light, a clean bench and a way to hold the carrier steady. Replace the pinion seal and check the axle shaft seals while the front is open. Watch for shaving on the magnetic drain plug and oil that smells burnt, both signs the gears are wearing unevenly.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 1-2094-342 |
| UPC | 631410093056 |
| Gear ratio | 3.42 |
| Axle location | Front |
| Axle type | GM 7.25 inch IFS |
| Popular axle manufacturer | GM |
| Series | O.E.M. |
Vehicle fitment
The set is matched to the GM 7.25 inch IFS at a 3.42 ratio. Confirm the axle type before ordering.
Only the GM 7.25 inch IFS is named for this 3.42 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and bearing preload on the IFS 3.42 gears should be set by a driveline shop before the front axle is run in.
What’s included
A matched O.E.M. series ring and pinion for the 7.25 inch IFS front axle.
















