Overview
The Crown Automotive 4874302 is a front passenger side Dana 30 axle shaft for the 1997 to 2006 Jeep Wrangler (TJ), the 1984 to 2001 Jeep Cherokee (XJ) and the 1987 to 1995 Jeep Wrangler (YJ).
It is a passenger side assembly with 27 splines, and Dana is named as the axle manufacturer.
Key features
- Front passenger side assembly
- Dana 30 axle type
- 27 splines
- Direct fit design
Front axle shaft care
A front axle shaft transfers power from the differential to the wheel while the suspension and steering move through their travel. Each end of the shaft has a joint that bends as the wheel turns and rises, so the joints and their rubber boots take most of the wear. A torn boot lets grease escape and dirt in, which can lead to joint noise and vibration over time.
On a Dana 30 front, check the boots and joints whenever the axle is serviced or the tires are off. Tire wear that changes with steering can also point to a bent or worn shaft. Because the passenger and driver shafts are separate parts, a shaft with a bad joint is often replaced on its own, while a set that has been run hard may be better replaced together.
- Look for cracked or torn joint boots
- Listen for clicks when turning under load
- Check for vibration at highway speed
- Replace the boot or joint before dirt damages the shaft
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 4874302 |
| UPC | 848399009651 |
| Axle location | Front |
| Axle type | Dana 30 TJ |
| Shaft location | Passenger side assembly |
| Axle spline | 27 splines |
| Axle manufacturer | Dana |
Vehicle fitment
It fits the 1997 to 2006 Jeep Wrangler (TJ), the 1984 to 2001 Jeep Cherokee (XJ) and the 1987 to 1995 Jeep Wrangler (YJ), which use the Dana 30 front axle.
Later generations, such as the Wrangler JK, are not covered by that wording. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One front passenger side axle shaft assembly.
Not included: the driver side axle shaft, which is a separate part.








