Overview
The G2 Axle and Gear 98-2031-002 is a Dana 30 front chromoly axle kit with 30 splines for 1987-1995 Jeep Wrangler (YJ) with a disconnect eliminator, 1997 and newer Wrangler (TJ) and 1984-2001 Cherokee (XJ), for use with a 30 spline aftermarket differential.
The 98-2031-002 is built from high-strength 4340 chrome/nickel (chromoly) alloy, forged for off-road driving, oversized tires and high-torque, ultra-low-geared vehicles. Extra material around the yoke area of the u-joint cap helps prevent distortion that can damage bearings. It has 30 splines, so the differential or carrier it works with must use the same spline count.
Key features
- Front axle kit for the Jeep Dana 30
- 30 spline, for use with a 30 spline aftermarket differential
- Forged from 4340 chrome/nickel alloy (chromoly).
- Extra material around the yoke area of the u-joint cap.
- Uses the 5-760X joint
- Fits YJ with a disconnect eliminator, TJ and XJ
Gearing, tires and axle matching
Larger tires and lower gearing put more load through the axle shafts, U-joints and bearings than stock setups see. Before changing either, check that the differential, carrier and axle shafts share the same spline count, since mismatched parts cannot be run together. Gearing changes can also affect how hard the drivetrain works at low speed, so plan the tire and gear combination as one project rather than replacing parts one at a time.
When a chromoly shaft goes in, the U-joint, clips and bearings are often replaced at the same time. Clean the axle tube and inspect the seal surfaces, then use fresh grease and new hardware where the old parts show wear. Driving habits matter too. Slow, smooth starts and careful throttle use on loose terrain put less shock on the shaft than hard, repeated launches.
Specifications
The 98-2031-002 is a chromoly front axle kit for the Dana 30 front axle (Dana 30 Reverse type), with 30 splines. The figures in the table below are for the 98-2031-002.
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 98-2031-002 |
| UPC | 631410097436 |
| Part type | Chromoly front axle kit |
| Axle | Dana 30 front (Dana 30 Reverse type) |
| Spline | 30 spline |
| Material | 4340 chrome/nickel alloy (chromoly) |
| U-joint | Uses 5-760X joint |
| Differential | For use with a 30 spline aftermarket differential (none included) |
| Application stated | 87-96 YJ with disconnect eliminator, 97-Up TJ, 84-01 XJ |
Vehicle fitment
It fits 87-96 YJ with a disconnect eliminator, 97-Up TJ and 84-01 XJ. Those years cover the 1987-1995 Wrangler (YJ) with a disconnect eliminator, the 1997-2006 Wrangler (TJ) and the 1984-2001 Cherokee (XJ). Confirm fit for your vehicle’s year, model and trim before ordering.
Before ordering the 98-2031-002, compare its spline count, side and overall length with the shaft being replaced.
The Jeep LJ, JK and JL are not covered by this fitment. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The kit is for use with a 30 spline aftermarket differential, so the differential must be 30 spline. It uses the 5-760X joint, and the YJ application is stated only for Jeeps with a disconnect eliminator.
What’s included
One axle shaft.
Not included: 30 spline aftermarket differential.

















