Overview
The G2 Axle and Gear 97-2031-002 is a Dana 30 chromoly inner axle shaft for the driver side, with 27 splines and a 16.50 inch overall length. It fits 1987-2006 Jeep Cherokee (XJ), Wrangler (YJ) and Wrangler (TJ) models with a 5-760X U-joint.
The shaft is built with rolled splines and forged, heat treated alloy steel that is made to exceed OEM specifications. It is designed for larger tires. Because the shaft and gear set engage through splines, the 27-spline 97-2031-002 needs a matching 27-spline differential or carrier. Its overall length marks it as the driver side inner shaft.
Key features
- Chromoly inner axle shaft for the Dana 30 front axle
- Driver side, 27 spline, 16.50 inch overall length
- Accepts a 5-760X U-joint
- Machined to accept full circle clips
- It fits Jeep XJ, YJ and TJ models from 1987 to 2006.
Matching a Dana 30 setup
The Dana 30 driver side inner shaft works with the differential through its splines, so spline count and side must match before any other check. A shaft with the wrong count will not seat properly and will wear the side gear. Measure the old shaft’s overall length and compare it with the new one. A shorter or longer shaft can change how the axle sits in the housing and how the U-joint angles.
Several parts are often replaced together on a Dana 30 front axle. Worn U-joints, axle seals and the hub bearing are common companions, since they share the same load path. When the front axle is apart, inspect the pinion seal and the carrier bearings. Fresh clips and a clean differential opening help the new shaft seat and reduce noise once the vehicle is back on the road.
- Count the splines against the differential
- Compare overall length with the old shaft
- Replace the U-joint if it shows wear
- Check the hub bearing and axle seal during the job
Specifications
The 97-2031-002 is a chromoly inner axle shaft for the Dana 30 front axle, also known as Dana 30 Reverse and Dana 30 TJ. It has 27 splines and an overall length of 16.50 inches.
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2031-002 |
| UPC | 631410096996 |
| Part type | Chromoly inner axle shaft |
| Axle | Dana 30 front (also known as Dana 30 Reverse and Dana 30 TJ) |
| Axle shaft location | Driver side inner |
| Spline | 27 spline |
| Overall length | 16.50 inches |
| U-joint | Accepts 5-760X U-joint |
| Clip design | Machined to accept full circle clips |
| Application stated | 87-06 Jeep XJ/YJ/TJ with 5-760X U-joint |
Vehicle fitment
It fits 87-06 Jeep XJ, YJ and TJ models with a 5-760X U-joint. That covers the 1987-2001 Cherokee (XJ), 1987-1995 Wrangler (YJ) and 1997-2006 Wrangler (TJ).
Fitment covers 87-06 Jeep XJ, YJ and TJ with a 5-760X U-joint.
Check the old shaft’s spline count and length against the 97-2031-002 specifications before you start the job.
It fits Jeep XJ, YJ and TJ models from 1987 to 2006. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
This is the short driver side inner shaft; the matching passenger side inner shaft is a different, longer part. The shaft accepts the 5-760X U-joint and full circle clips, so check that the front axle uses that U-joint size.








