Overview
The G2 97-2031-001 is a chromoly outer axle shaft for Dana 30 and Dana 44 front axles. It has 27 splines, an overall length of 6.15 inches and accepts a 5-760X U-joint. It is made for either the driver or passenger side.
It fits the Jeep XJ, YJ and TJ with a 5-760X U-joint. The years covered are 1984–2001 for the Cherokee (XJ), 1987–1995 for the Wrangler (YJ) and 1997–2006 for the Wrangler (TJ).
G2 says its shafts are forged from high grade alloy steel and heat treated to exceed OEM specifications, and that they are engineered to handle the added load of high torque applications. Big spline options and rolled splines are part of the design.
It fits Dana 30 variants, including the Dana 30 TJ, and Dana 44 variants. The shaft is machined to accept full circle clips.
Key features
- Outer stub with 27 splines
- Available for either side of the front axle.
- Accepts a 5-760X U-joint
- Machined to accept full circle clips
- Chromoly construction, forged and heat treated
Axle shaft wear and replacement
An outer axle shaft carries drive torque from the differential to the wheel hub, so its splines and retainers take constant stress. Wear shows up at the spline ends, the U-joint end and where the clips sit. Inspect them whenever the axle is opened, and check that the retaining clips seat fully in their grooves.
Front axles see different loads on trail and highway use, so the shaft should be matched to the hub and joint. Keep the U-joint lubricated and the axle seals intact, since water and grit drive wear quickly. Chromoly shafts are strong, but a bent or cracked shaft should be replaced rather than straightened.
- Inspect spline ends and clip grooves
- Lubricate the U-joint during service
- Replace bent or cracked shafts
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2031-001 |
| UPC | 631410096989 |
| Axle location | Front |
| Axle types | Dana 30 and Dana 44 variants |
| Position | Outer stub, driver and passenger |
| Spline | 27 |
| Overall length | 6.15 inches |
| U-joint | 5-760X |
| Retainer | Machined for full circle clips |
Vehicle fitment
The fitment covers the 1984–2001 Jeep Cherokee (XJ), the 1987–1995 Jeep Wrangler (YJ) and the 1997–2006 Jeep Wrangler (TJ) with a 5-760X U-joint. Check fit against the model years and U-joint size before ordering.
The fitment does not extend to other Jeep models or to axles with a different U-joint. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The shaft uses a 5-760X U-joint on the axle end and full circle clips for retention. Check the U-joint size and clip fit before installing, because the shaft is machined for those parts.
What’s included
Both driver and passenger sides are available. Check the package contents against your installation before starting.






