Overview
The Bilstein 5100 Series 24-185752 is a gas-charged monotube shock absorber for the 1986–1989 Toyota 4Runner and the 1986–1995 Toyota Pickup. It uses 16mm eye mounts at both the lower and upper ends, a different setup from the stem-mounted 5100 units.
Collapsed length is 16 in, extended length is 25.63 in and travel is 9.63 in. Confirm front or rear against the mounting points on your truck or 4Runner before fitting.
Key features
- Monotube body with gas charge
- Zinc plated finish
- 14mm shaft diameter
- 46mm ID body, non-coilover design
- Boot included
Eye-to-eye fitment basics
Eye mounts at both ends are a simple, bolt-through style that many older trucks used. Matching the eye diameter to the bolt or pin on your bracket is the first step, and the collapsed and extended lengths decide whether the reach is right. Eye mounts can wear at the bushings, so inspect the eye and sleeve before fitting.
Older trucks often have seized fasteners, so penetrating oil and a fresh set of bolts help avoid trouble during install. Check that the shock clears the frame, axle and any brake lines through the full range of travel. Gas-charged units hold pressure, so avoid heat near the tube.
- Measure eye and pin diameters before ordering
- Inspect rubber bushings for splits
- Check clearance through full travel
- Replace rusted hardware while the shock is off
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-185752 |
| UPC | 651860453880 |
| Series | 5100 Series |
| Collapsed length | 16 in |
| Extended length | 25.63 in |
| Travel length | 9.63 in |
| Lower mount | Eye, 16mm |
| Upper mount | Eye, 16mm |
| Shaft diameter | 14mm |
| Body design | 46mm ID smooth body, non-coilover |
| Internal design | Mono tube |
| Gas charged | Yes |
| Reservoir | No |
| Finish | Zinc plated |
| Boot | Included |
Vehicle fitment
It fits the 1986–1989 Toyota 4Runner in DLX and SR5 trims, and the 1986–1995 Toyota Pickup in Base, Base Turbo, DLX, SR5 and SR5 Turbo trims.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Both ends use 16mm eyes, so match the bolts or pins on your truck to those eyes before fitting. Check the 16 in collapsed length against your current shock to confirm it is the right reach.
What’s included
One shock absorber with boot included. Check which mounting hardware your installation requires before starting.








