Overview
The Bilstein 24-185509 is a rear 5100 Series gas-pressure monotube shock absorber with 16mm eye mounts at both ends. It is rated for a 4 in. lift. It fits 1984–1990 Ford Bronco II, 1983–2011 Ford Ranger and several 1998–2009 Mazda B-series trucks.
The 5100 Series uses traditional single-tube technology with high gas pressure, built for fade-free performance and long life on lifted trucks, Jeeps and prerunners. It has self-adjusting valving and an enlarged working piston area, and it is designed for lift kits that keep the stock OEM mounting layout.
Key features
- Gas-pressure single-tube monotube construction
- Self-adjusting deflecting disc valving
- High-flow piston intended to reduce harshness
- Independent rebound and compression tuning
- Designed for lift kits using stock OEM mounting
- Boot included, zinc plated finish
Matching shock length to lift
A rear shock controls body movement over the axle, and it works hardest when a lift changes the suspension geometry. A replacement must suit how far the suspension travels. Measure your current rear shock and compare the collapsed and extended figures with the new unit so it does not bind at full droop or run out of stroke at full compression.
Eye-to-eye mounts put load on the bushings at each end. Worn bushings let the shock wobble and can make a new unit feel loose, so inspect them whenever the shock comes off. Look for cracks, flattened rubber or play in the eye. Replacing shocks in pairs on the same axle keeps the ride balanced from side to side.
- Check that the eye size matches the bracket or bushing
- Look for oil streaks on the body, which can mean a seal has failed
- Inspect the shaft for bends or scrapes after rough trail use
- Re-torque the mount bolts after the first few trail runs
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-185509 |
| UPC | 651860453590 |
| Shock series | 5100 Series |
| Position | Rear |
| Design | Monotube, gas charged |
| Collapsed length | 16.14 in |
| Extended length | 26.16 in |
| Travel length | 10.02 in |
| Lower mount | Eye 16mm |
| Upper mount | Eye 16mm |
| Shaft diameter | 14mm |
| Body design | 46mm ID smooth body (non-coilover) |
| Finish | Zinc plated |
| Reservoir | No |
| Boot included | Yes |
| Lift | w/4 in. Lift |
Vehicle fitment
It fits 1984–1990 Ford Bronco II (Base, Eddie Bauer, XL, XL Sport, XLS, XLT, XLT Plus); 1983–2011 Ford Ranger (Base through XLT, including Tremor and Splash); 2001–2009 Mazda B2300; 1998–2001 Mazda B2500; 1998–2001 and 2003–2007 Mazda B3000; and 1998–2000 Mazda B4000.
Ford Explorer and Ford full-size trucks are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Both ends use 16mm eyes, so the shock needs matching eye-type brackets or bushings at the upper and lower mounts. Compare the collapsed length of 16.14 in with your current shock before installation.
What’s included
One Bilstein 5100 Series rear shock absorber with boot included.
Not included: Mounting bushings and hardware are not included with this part.









