Overview
The Bilstein 24-185073 is a rear monotube gas-charged shock absorber in the 4600 Series, and the manufacturer fitment list ties it to the 2005–2015 Toyota Tacoma (Base). It is the rear position, so it damps rear axle movement on the listed truck. Owners replacing a rear Tacoma shock with a 2 in body diameter monotube unit can compare the specifications below.
This shock uses a single-tube body with a dividing piston and a gas charge. The piston lets oil expand as temperature climbs, which prevents aeration and the loss of viscosity that reduces damping. Heat travels from the oil to the outer surface of the body, and the extruded tube holds tight tolerances with consistent wall thickness. The piston head design lets compression and rebound be tuned independently, and the design has fewer parts than conventional twin tube shocks.
Key features
- Rear position in the 4600 Series monotube line
- Gas-charged body with a dividing piston for oil expansion
- Extruded tube with tight tolerance and even wall thickness
- Independent compression and rebound tuning at the piston head
- Fewer parts than most conventional twin tube designs
- Dust boots included
Rear suspension care
A rear shock manages axle movement, so wear shows up as hopping on uneven pavement, bounce after bumps, or uneven rear tire wear. Gas-charged monotube bodies handle heat better than many older designs, which helps during long drives or work with a load in the bed. Still, the seals and bushings wear with use, so inspect them regularly.
Rear shocks are often replaced as a matched pair so both sides damp the same way. When the old unit comes off, check the mounting bushings, the bolts and the dust boot before installing the new one. Keep the boot intact, since grit that reaches the shaft shortens seal life.
- Check the mounting bushings for cracks
- Inspect the boot for tears
- Look for oil film on the shaft
- Replace as a pair when wear is uneven
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-185073 |
| UPC | 651860562186 |
| Shock series | 4600 Series |
| Position | Rear |
| Type | Monotube, gas charged |
| Body diameter | 2 in |
| Reservoir | No |
| Boots included | Yes |
| Finish | Yellow |
| Lift height | 0 in lift/drop |
| Fitment type | Direct fit |
Vehicle fitment
This rear shock covers the 2005–2015 Toyota Tacoma in the Base trim only.
Front shocks and other Toyota models are not covered by this rear entry. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This shock is sold as one unit. Rear shocks are often replaced as a matched pair on the same axle when wear is uneven, which keeps handling balanced.
What’s included
One rear shock absorber with dust boots.
Not included: the second rear shock needed for a pair.









