Overview
The Bilstein 24-016971 is a 4600 Series monotube gas-charged front shock absorber with a 2 inch body diameter and a yellow finish. It is designed for 1988-2000 Chevrolet C-series trucks and 1988-2000 GMC C-series trucks and Suburbans.
The monotube gas-charged design carries heat from the oil to the outer surface of the shock body, where it dissipates efficiently. A dividing piston lets the oil expand as it heats, which prevents aeration (foaming) and loss of viscosity. The shock keeps its full damping characteristics as temperatures rise.
The tube is made by a special extrusion method that gives a tight peak-to-valley tolerance and consistent wall thickness. The piston head design allows compression and rebound damping to be tuned independently. The shock is designed for 0 in. lift or drop, with boots included and no reservoir.
Key features
- Monotube, gas-charged design
- Bilstein 4600 Series, front position
- 2 inch body diameter
- Yellow finish
- Boots included
- No reservoir
- Designed for stock height (0 in. lift or drop)
- Seamless extruded tube with consistent wall thickness
Signs a front shock needs replacing
Front shocks wear over time, and worn units often show up as bouncing after bumps, nose dive under braking or fluid seeping down the body. Because the shock controls wheel movement, a worn unit can make tires cup or wear unevenly. Check the shock body and boot for leaks and cracks during each tire rotation.
Monotube gas-charged shocks are sealed units and are generally replaced in pairs on an axle to keep handling balanced. Replacing only one side can leave the truck pulling or riding at uneven heights. Match the replacement to the stock ride height, and keep a record of the part installed for future service.
- Look for oil leaks along the shock body
- Check boots for cracks or tears
- Replace shocks in pairs on the same axle
- Listen for knocking at the mounts
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-016971 |
| UPC | 651860464428 |
| Product type | Monotube shock absorber |
| Series | 4600 Series |
| Position | Front |
| Body diameter | 2 inch |
| Type | Monotube, gas charged |
| Finish | Yellow |
| Reservoir | No |
| Boots | Included |
| Lift height | w/0 in. lift/drop |
| Fitment type | Direct fit |
Vehicle fitment
The stored manufacturer fitment list for the Bilstein 24-016971 covers the 1988-1999 Chevrolet C1500, the 1988-2000 Chevrolet C2500 and C3500, the 1988-1999 GMC C1500, the 1988-1998 GMC C2500, the 1992-1998 GMC C2500 Suburban and the 1988-2000 GMC C3500, in the trims listed in the manufacturer data.
Only the years and models above are covered. Other model years and other Chevrolet or GMC models are not part of this fit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Suspension, steering and axle components are safety-critical, so professional installation is recommended. Follow the installation steps and torque every fastener to the specified values.
- Support the vehicle on rated jack stands on level ground; never work under a vehicle held only by a jack.
- Inspect nearby bushings, mounts and hardware while the area is open, and replace anything worn.
- Re-check fastener torque after the first miles of driving, and again at regular service intervals.
- Have the alignment checked after any suspension or steering work.
- Confirm tire, brake line and wiring clearance through the full range of suspension travel before driving normally.
What’s included
One Bilstein 4600 Series shock absorber with boots.
Not included: Additional shocks for other positions and mounting hardware.









