Overview
The Artec Industries JK4401 is a Dana 44 front axle truss for 2-door and 4-door Jeep Wrangler JK models. It is designed to reinforce the front axle housing and is built from heavy duty, lightweight truss components.
Its 1/4 inch thick truss top and 10Ga. gussets are designed to brace both axle tubes, not just the long tube. The kit suits vehicles with at least minor lifts. On an unlifted vehicle, check clearances before installing. It has not been tested on non-US JKs with diesel engines or right hand drive axles.
Key features
- Braces both front axle tubes rather than only the long tube.
- Truss spans the long side and the short side of the axle.
- Precision cut and formed components, which the brand says make installation straightforward.
- Mild steel construction with a 1/4 inch top and 10Ga. gusseting.
- Designed for vehicles with at least minor lifts.
- Built for 2 and 4-door JK models with a Dana 44 front axle.
Before you weld
Good results start with an axle that is sound before any bracing goes on. Inspect the housing for cracks, bent tubes and old weld repairs, and check the center section for damage. A truss cannot correct a bent axle, so any problem found at this stage should be addressed first.
Set the truss in place and confirm clearance to brake lines, the differential cover and the steering components before welding. Keep heat away from the cast center section where possible, and let the assembly cool before checking alignment. Recheck the fit after cooling, since welds can shift the position slightly.
- Inspect the axle housing for cracks before fitting
- Confirm brake line and steering clearance first
- Let the assembly cool before final alignment checks
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | JK4401 |
| UPC | 816791021694 |
| Axle type | Dana 44 |
| Axle location | Front axle |
| Fitment type | Direct fit |
| Steering ram mount | Without steering ram mount |
| Material | Mild steel |
| Truss top thickness | 1/4 inch |
| Gusset gauge | 10Ga. |
| Models | 2 and 4-door |
Vehicle fitment
It is a direct fit for the 2007–2018 Jeep Wrangler JK with a front Dana 44 axle on 2-door and 4-door models. It does not include a steering ram mount.
Not covered: Dana 44 rear axles, and non-US JKs with diesel engines or right hand drive axles, which the brand has not tested. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires welding to the cast center section, so general welding and fabrication skills are needed. The precision cut and formed components help the fit, but a poorly made weld on the cast center section can compromise the truss. An experienced fabricator should do that work.
What’s included
The kit is the front axle truss and armor, made from cut and formed components.
Not included: steering ram mount.











