Overview
The Alloy USA 15139 is a Ford 8.8 rear axle shaft for the passenger side, with 28 splines. It fits the 1993-1997 Ford Ranger.
The shaft is made from 1541H or 4140 steel, heat treated and induction hardened. Its 28 splines only engage gears cut for 28 splines, so the differential or carrier must match. The Ford 8.8 name alone does not confirm the spline count, so check the count on the axle being repaired. Compare the removed shaft’s spline count and length before fitting.
Key features
- Replacement shaft for the Ford 8.8 rear axle
- 28 spline
- Passenger side
- Fits the 1993-1997 Ford Ranger.
- Alloy USA says its shafts are heat treated and induction hardened
- Bearings, seals and studs are not included
- Axle: Ford 8.8 inch rear
- Axle shaft location: Passenger side (rear right)
Checking spline count first
The 28 spline count on this shaft is the first thing to confirm, because splines that do not match will not engage the gear set. Spline count and axle type are separate checks, since the Ford 8.8 name alone does not guarantee the same count across all years. Compare the removed shaft’s count and length before fitting, and keep the passenger side location in mind.
Ranger drivetrains are often used for trail and work trips, where shafts take repeated shock from uneven ground and hard launches. Upgraded shafts help with fatigue, but they cannot make up for a worn carrier or damaged bearings, so inspect the axle as a whole. Wheel bearings, seals and studs are often replaced during the same job.
- Count splines on the old shaft and the carrier gears
- Replace the wheel bearing and seal set with the shaft
- Inspect the carrier for wear before installing
- Confirm the passenger side shaft is the correct side
Specifications
The 15139 is a replacement axle shaft for the Ford 8.8 inch rear axle, with 28 splines. Every figure in the table below is the manufacturer value for the 15139.
| Brand | Alloy USA |
|---|---|
| Part number | 15139 |
| Part type | Replacement axle shaft |
| Axle | Ford 8.8 inch rear |
| Axle shaft location | Passenger side (rear right) |
| Spline | 28 spline |
| Manufacturer part number | ALY15139 |
| Application stated | 93-97 Ford Ranger |
Vehicle fitment
The manufacturer fitment list for the 15139 names: 1993–1997 Ford Ranger.
It is for 93-97 Ford Ranger applications.
Match the 15139 against your old shaft for spline count, length and driver or passenger side before installing it.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 15139 arrives without bearings, seals or studs, so plan to reuse the originals or have new ones on hand.
What’s included
One axle shaft.
Not included: Bearings, Seals, Studs.







