Overview
The S&B Filters 75-5108 is an oiled-filter cold air intake kit for the 2011–2016 Ford F-250 Super Duty and F-350 Super Duty with the 6.2L engine. Its large airbox is sized to use as much of the available space as possible while mounting to the stock positions, and the intake tube runs in one clean line from the throttle body to the airbox.
The kit uses a foam MAF gasket with an injection-molded MAF plate to seal around the mass airflow sensor. S&B rates its silicone filter, couplers and tube seal for temperatures up to 400 F. The filter is listed at 12.20% more airflow than the stock intake and 99.47% efficiency at 482 CFM (ISO Coarse Dust).
Key features
- Large airbox that mounts to the stock mounting positions
- Cotton oiled filter with a listed oil quantity of 80 grams
- Intake tube run in one line from throttle body to airbox, with minimal obstructions
- Injection-molded MAF plate and foam MAF gasket for a seal around the MAF sensor
- Silicone filter, couplers and tube seal, rated up to 400 F
- Full-color, step-by-step instructions provided
Oiled filter service intervals
Oiled filters need routine attention. Clean and re-oil the element when it looks loaded, and avoid heavy coats that can reach the sensor. Inspect the silicone tube seals for hardening or cracks during oil changes, since heat cycling in the engine bay is what wears them out first. Replace worn couplers before they start to leak, because a small leak can change idle and throttle response.
A cold air intake relies on its sealing points, so the MAF plate, gasket and tube couplers should be treated as part of the job rather than extras. Seat the gasket evenly and confirm the sensor is square before tightening. After installation, check that the couplers sit fully on their nipples and that no hose rubs against the engine bay.
- Check MAF gasket seating after the first drive
- Inspect silicone couplers for hardening or cracks
- Wipe the sensor area during each filter service
- Keep oil off the MAF sensor element
Specifications
| Brand | S&B Filters |
|---|---|
| Part number | 75-5108 |
| UPC | 841372037412 |
| Engine | 6.2L |
| Filter type | Oil (cotton) |
| Filter housing type | Full enclosure |
| Intake type | Cold air |
| Inlet tube | Included |
| Fitment type | Direct fit |
| Airflow vs. stock intake | 12.20% more |
| Filter efficiency | 99.47% at 482 CFM (ISO Coarse Dust) |
| Oil quantity | 80 grams |
| Silicone rating | Up to 400 F |
Vehicle fitment
S&B’s manufacturer list covers the 2011–2016 Ford F-250 Super Duty and Ford F-350 Super Duty, with King Ranch, Lariat, Platinum, XL and XLT trims.
Other Ford trucks and model years outside 2011–2016 are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation can be done in under 60 minutes with basic tools, using the full-color, step-by-step guide included with the kit. Because the kit includes a MAF plate and gasket, make sure the sensor seal is fully seated before starting the engine.
What’s included
The kit includes the airbox with the oiled filter, the intake tube, the foam MAF gasket, the injection-molded MAF plate, the silicone couplers and tube seal, and the instructions. The oil quantity is 80 grams. Check the package contents to confirm whether oil is included.


















