Overview
The S&B Filters 75-5085D is a dry-filter cold air intake kit for the 2017 Ford F-250 and F-350 Super Duty with the 6.7L Powerstroke diesel. It uses a fully enclosed airbox with a dry extendable filter, and the intake box and battery are relocated so the intake sits closer to, and directly in line with, the front air inlet.
The kit has two airflow setups. Installing the included silicone box plug seals the airbox so the front-facing primary inlet scoop is the main air source. The intake tube has minimal bends between the airbox and the turbo inlet, which the manufacturer links to a significant decrease in restriction compared with the stock intake.
Key features
- Dry extendable filter housed in a full enclosure airbox
- Front-facing primary inlet scoop becomes the main air source when the box plug is used
- Intake tube with minimal bends from the air inlet to the turbo inlet
- Injection-molded MAF sensor plate with a foam MAF sensor gasket for a sealed connection
- 54.86% more airflow than the stock intake
- 99.73% efficiency at 580 CFM (ISO Coarse Dust)
Sealing the MAF connection
The mass airflow sensor reads incoming air, so a leak at its connection can throw off the engine’s air reading. The injection-molded MAF sensor plate and the foam gasket are there to seal the connection. Clean the mounting surface before fitting the plate, and make sure the gasket sits flat without twisting.
A dry extendable filter is not oiled, so keep oil and cleaners away from the sensor area. Once the plate is in place, check it by hand for movement. Recheck the seal after the first service, since heat cycles can change how gaskets sit. A small leak is easier to fix during installation than after the first long drive.
- Clean the mounting surface
- Keep oil away from the sensor
- Recheck the seal after the first service
Specifications
| Brand | S&B Filters |
|---|---|
| Part number | 75-5085D |
| UPC | 841372037139 |
| Engine | 6.7L Powerstroke (Ford) |
| Filter type | Dry, extendable |
| Filter housing type | Full enclosure |
| Intake type | Cold air |
| Fitment | Direct fit |
| Inlet tube | Included |
| Silicone box plug | Included |
| Airflow gain | 54.86% more than the stock intake |
| Filter efficiency | 99.73% at 580 CFM (ISO Coarse Dust) |
| CARB EO# | D-590-17 |
Vehicle fitment
The manufacturer fitment list covers the 2017 Ford F-250 Super Duty and 2017 Ford F-350 Super Duty, including King Ranch, Lariat, Platinum, XL and XLT trims.
Other model years and Super Duty models fall outside the coverage shown here. Confirm fit for your year, model and trim before ordering.
Installation notes
The kit relocates the battery as part of the intake change. The manufacturer puts the job at 90 minutes or less with standard tools, following its installation instructions. Disconnect the battery before starting the relocation.
What’s included
The inlet tube and silicone box plug are included. Check the packing list for the foam MAF sensor gasket and injection-molded MAF sensor plate before starting.
















