Overview
The Rubicon Express Control Arm Adjustable Front Lower, part number RE3751, is a fully adjustable lower control arm for the front of a 2007–2018 Jeep Wrangler JK. Rubicon Express writes the arm for the Jeep JK Wrangler, and it can be set up for pinion and caster or used as a replacement for a damaged factory arm.
The arm is made from thick wall DOM tubing and uses the Rubicon Super-Flex joint, which is built for long service. It gives a short arm suspension more adjustment and lets the axle move without restraint off road.
The adjustment range runs from factory length to +1. That range covers pinion, caster and wheelbase setups. The arms are powder coated for corrosion resistance and are covered by the Rubicon Express Advantage Warranty.
Key features
- Fully adjustable, from factory length to +1
- Rubicon Super-Flex joint
- Thick wall DOM tubing
- Powder coated for corrosion resistance
- Covered by the Rubicon Express Advantage Warranty
- Mounts at the front lower position
Setting up adjustable arms
An adjustable lower control arm changes the geometry the axle works within, so the setting you choose affects how the vehicle tracks and how the axle sits under load. Measure pinion and caster before and after any change, and make small, equal adjustments on both sides. Confirm that the arms reach their adjustment points cleanly before tightening, since uneven setup can cause binding and tire wear.
Joints and bushings wear over time, and a worn joint can allow play that shows up as wandering or clunking over bumps. Inspect the joint for looseness, boots for cracks and the mounting hardware for movement after rough trail use. Re-check alignment after any adjustment, and keep a note of your settings so the same geometry can be restored after service.
- Make equal adjustments on both sides
- Check joints and mounts after rough trail use
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE3751 |
| UPC | 614901440591 |
| Mounting location | Front lower |
| Adjustment | Factory length to +1 |
| Tubing | Thick wall DOM |
| Joint | Rubicon Super-Flex |
| Finish | Powder coated |
| Sold as | Pair |
Vehicle fitment
These arms fit the Jeep Wrangler (JK) from 2007 to 2018.
This entry covers the JK generation only, not the JL or the TJ and YJ Wranglers. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Adjusting pinion and caster changes the alignment, so have the vehicle aligned after the arms are installed and set.
What’s included
A pair of adjustable front lower control arms.

