Overview
The Rough Country 1161 is a set of three carrier bearing shims with hardware, for 2003–2016 Dodge Ram 2500 and 3500 trucks. The kit is for vehicles with a two-piece driveshaft and carrier bearing, such as the Mega Cab, where take-off vibration can occur.
Take-off vibration can be corrected by shimming the carrier bearing down. How many shims are needed depends on how severe the vibration is.
Key features
- Three carrier bearing shims
- Hardware included
- Designed for two-piece driveshaft and carrier bearing setups
- Corrects take-off vibration by lowering the carrier bearing
- Direct fit to the listed trucks
Two-piece driveshaft basics
Two-piece driveshafts have a center support bearing that holds the shaft in place, and its height affects the angle at each joint. Take-off vibration often shows up when pulling away from a stop because joint angles change under torque. Shimming the carrier bearing down changes that geometry, which can calm the shaft without replacing parts.
Because the number of shims depends on how severe the vibration is, start with the setup that matches the symptoms and recheck on the road. Confirm the driveshaft type before ordering so the kit is used on a two-piece application. Worn U-joints or a loose carrier bearing can produce similar symptoms, so inspect those parts when the vibration persists.
- Confirm the truck has a two-piece driveshaft
- Test at low speed and under light throttle
- Check the carrier bearing for play
- Inspect U-joints before shimming further
Specifications
| Brand | Rough Country |
|---|---|
| Part number | R/C1161 |
| Quantity | Three shims with hardware |
| Driveshaft | Two-piece driveshaft and carrier bearing |
| Fitment | Direct fit |
Vehicle fitment
It fits the 2003–2010 Dodge Ram 2500 in Laramie, Power Wagon, SLT, ST, SXT, Sport, TRX and TRX4 trims, and the 2003–2010 Dodge Ram 3500 in Laramie, SLT, ST, SXT, Sport and TRX4 trims. It also fits the 2011–2016 Ram 2500 and 3500 in their covered trims.
Trucks with a one-piece driveshaft are not the application for this kit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Shimming down the carrier bearing corrects take-off vibration. The number of shims depends on how severe the vibration is, so check the setting on the road after installation.







