Overview
The Rough Country N3 front shock R/C23191_A is a nitrogen-charged twin-tube shock for Dodge Ram 2500 and Ram 3500 trucks with a 3 to 4.5 inch lift. It uses a stud at the top and a bar pin at the bottom, and it is sold as a pair.
Twin-tube shocks keep a reserve of fluid in an outer tube around the working cylinder. This N3 version adds a ten-stage variable valving circuit, so the damping is tuned to suit both paved roads and rougher trails. The extended length is 27.34 in and the compressed length is 16.10 in, which is the travel the shock needs when the suspension is at full droop and full compression.
Key features
- Nitrogen charged for consistent damping
- 10-stage variable valving across a range of speeds
- 35mm piston with an 18mm chrome-hardened piston rod
- 54mm shock body designed to shed heat faster
- Rated to 36kN tensile strength
- Spring-loaded piston rod seal and rubber bushings
- Military spec damper fluid
Inspecting the bar pin mounts
A bar pin bottom mount relies on a pin through the bracket, so wear at the pin and its bushing is a common source of noise. Check the pin for play, look for worn or cracked rubber, and make sure the pin is seated fully. A loose pin can change steering feel and lead to uneven tire wear over time.
Twin-tube shocks are sensitive to how they are mounted, because a bent or misaligned bracket puts side load on the body and piston rod. After installing the shocks, check the mounts for clearance at full travel and recheck the alignment, since a lift changes caster. Replace the pair together so both fronts stay matched, and keep the hardware clean during routine service.
- Check pin play by hand
- Inspect rubber bushings for cracks
- Recheck clearance at full droop
Specifications
| Brand | Rough Country |
|---|---|
| Part number | R/C23191_A |
| Product line | N3 Performance |
| Shock type | Twin-tube shock kit |
| Position | Front |
| Lift height | 3-4.5 in. |
| Top mount | Stud |
| Bottom mount | Bar pin |
| Extended length | 27.34 in |
| Compressed length | 16.10 in |
| Body diameter | 54mm |
| Piston | 35mm |
| Piston rod | 18mm chrome-hardened |
| Charge | Gas charged, nitrogen |
| Valving | 10-stage variable |
| Tensile strength | 36kN |
| Finish | Metallic silver paint |
| Warranty | 3-year warranty |
| Sold as | Pair |
Vehicle fitment
The shock fits the 2003–2010 Dodge Ram 2500 and 2003–2010 Dodge Ram 3500, the 2011–2013 Ram 2500 and the 2011–2026 Ram 3500. It is built to fit those models with a 3 to 4.5 inch lift.
The list does not include Ram 1500 trucks or 2014 and newer Ram 2500 trucks. For those, Rough Country’s other N3 front shocks are sized for different lift heights. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The shock is a direct-fit replacement for the lifted front axle on the trucks above. Check the front alignment after the shocks go in, since a lift changes caster and the steering geometry.
What’s included
Sold as a pair: two N3 front shocks, one for each side.









