Overview
The Trail Gear Carrier Bearing Relocation Kit 302512-1-KIT moves the driveline carrier bearing back 1-1/8 inches for 2005–2014 Toyota Tacoma Base trucks. It is designed to account for the thickness of the 4.0L adapter plate.
The kit is required when a 4.0L adapter plate is installed onto a transmission with a gear drive transfer case. Its brackets and hardware are zinc-plated steel.
Key features
- Relocates the driveline carrier bearing back 1-1/8 inches
- Accounts for the thickness of the 4.0L adapter plate
- Zinc-plated steel brackets and hardware
- Required with a gear drive transfer case in this setup
Carrier bearing and driveline setup
The carrier bearing supports the driveshaft between the transmission and rear axle on a two-piece layout. Moving it back changes where the shaft runs and how the joints operate, so the new position has to keep the shaft in a healthy angle range. Sharp angles at the joints cause vibration and early wear, especially at highway speed.
Because the transfer case and driveshaft stay in place while the bearing shifts, the bracket geometry matters more than the bolts alone. Inspect the carrier bearing, its support and the mounting bolts after the first few drives, and check for rubbing near the exhaust or crossmember. Keep the removed bearing hardware until the new setup has proven out.
- Check driveline angles once the setup is complete
- Look for vibration at highway speed
- Re-torque mounting bolts after the first drives
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 302512-1-KIT |
| UPC | 700007701631 |
| Carrier bearing shift | 1-1/8 inches back |
| Material | Zinc-plated steel (hardware and brackets) |
| Compatibility | 4.0L adapter plate on a transmission with a gear drive transfer case |
| Fitment type | Direct fit |
Vehicle fitment
It fits 2005–2014 Toyota Tacoma trucks in the Base trim only.
Tacoma models outside 2005–2014 and other Toyota models are not covered. Check your year, model and trim before buying.
Installation notes
Relocating the carrier bearing changes the driveline geometry, so check the driveline angles once the kit is installed.
What’s included
Brackets and hardware for relocating the carrier bearing.
Not included: The 4.0L adapter plate is not part of this kit, so source it separately before installing the relocation brackets.










