Overview
The ICON Vehicle Dynamics 33700 is a carrier bearing drop kit for the Ford F-250 and F-350 Super Duty. It covers 1999–2022 trucks in the covered trims, and it can be adjusted for each truck it is installed on.
The carrier bearing supports the driveshaft, and some trucks need more drop than others to reduce vibration. The kit includes shims in 1/8, 1/4 and 1/16 inch thicknesses, which allow fine tuning of the drop to reduce driveline vibration.
Key features
- Shims in 1/8, 1/4 and 1/16 inch thicknesses
- Adjustable drop for each truck
- Minimizes driveline vibration
- Carrier bearing drop kit for the Super Duty
- Direct fit to the listed trims
Setting the drop
On a two-piece driveshaft, the carrier bearing sets the angles at each U-joint. When those angles do not match, vibration can show up under acceleration or at cruising speed. Shimming the drop is a way to bring the angles closer together without replacing other driveline parts.
Lift height, tire size and payload all change driveline angles, so a setting that works on one truck may not suit another. Work in small steps, test drive at several speeds, and note the shim combination that gives the smoothest result. If vibration returns, check the U-joints and the carrier bearing itself for wear, since worn parts can mimic an angle problem.
- Test at a range of speeds, not just one
- Keep a record of the shim stack used
- Inspect U-joints for play before adjusting
- Check the carrier bearing for rough rotation or play
Specifications
| Brand | ICON Vehicle Dynamics |
|---|---|
| Part number | ICO33700 |
| Type | Carrier bearing drop |
| Shims | 1/8, 1/4 and 1/16 inch |
| Fitment | Direct fit |
Vehicle fitment
It is for the 1999–2022 Ford F-250 Super Duty and F-350 Super Duty in Cabela’s, FX4, Harley-Davidson Edition, King Ranch, Lariat, Limited, Platinum, XL and XLT trims.
Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Install the shims in the combination needed to bring the carrier bearing to the right drop, and recheck the driveline vibration after the install. ICON says some trucks need more drop than others, so the shim stack should be set for the individual truck.



