Overview
The Rough Country 6557 is a 2 inch rear block and U-bolt kit for the 2005 to 2010 Ford F-250 Super Duty. It covers the Cabela’s, FX4, Harley-Davidson Edition, King Ranch, Lariat, XL and XLT trims, and it gives a 2 inch lift as a direct fit.
The kit replaces the factory block with two fabricated steel blocks that are tapered to reduce driveline angles. The steel blocks are stronger than standard cast blocks, and each block uses a single 9/16-inch pin that fits the factory axle pad. Vehicle-specific kits carry the Rough Country Satisfaction Guarantee.
The blocks are e-coated and corrosion resistant, with a powder coat black finish. The U-bolts are round in style with a 5/8-inch thread, a 3.625-inch inside width and a 16.5-inch inside length. The blocks are 2.5 inches wide.
Key features
- Two fabricated steel blocks, tapered to reduce driveline angle
- Single 9/16-inch pin that fits the factory axle pad
- Round U-bolts with 5/8-inch thread
- 3.625-inch inside width and 16.5-inch inside length on the U-bolts
- E-coated corrosion resistant hardware
Super Duty rear sag and load
Super Duty trucks carry heavy loads and tow often, which puts stress on rear springs and axle mounts. Over time springs can settle, and a block kit can restore some height and improve driveline angle under load. Blocks do not add load capacity, so check the rear axle weight rating before adding a heavier camper or trailer.
Blocks change the relationship between the axle and the frame, so the rear shocks and brake lines may need a look after installation. Longer brake lines or shock extensions are sometimes needed on larger lifts, depending on the vehicle. Inspect the spring pads, U-bolt threads and pinion angle after the first few trips.
- Check brake line length after installation
- Inspect rear shocks for travel limits
- Look at spring pads for cracks
- Verify pinion angle after the first trips
Specifications
| Brand | Rough Country |
|---|---|
| Part number | 6557 |
| Lift height | 2 inches |
| Block material | Fabricated steel |
| Block width | 2.5 inches |
| Pin | Single 9/16-inch |
| U-bolt style | Round |
| U-bolt thread | 5/8-inch |
| U-bolt inside width | 3.625 inches |
| U-bolt inside length | 16.5 inches |
| Finish | Powder coat black blocks, e-coated U-bolts |
| Fitment type | Direct fit |
| Vehicle | Ford F-250 Super Duty, 2005 to 2010 |
Vehicle fitment
It fits the 2005 to 2010 Ford F-250 Super Duty in the Cabela’s, FX4, Harley-Davidson Edition, King Ranch, Lariat, XL and XLT trims.
Other Super Duty years and the F-350 are not on the list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The kit includes two fabricated steel blocks and a set of e-coated corrosion resistant U-bolts. Check the nuts and washers in the box against your install plan.









