Overview
The Pro Comp Suspension 22250 is a 2.5 inch rear lift block with U-bolt kit. Each box holds two tapered cast iron riser blocks, four U-bolts, eight heavy duty flat washers and eight hi-nuts.
Key features
- 2.5 inch rear lift
- Tapered cast iron risers
- Complete U-bolt hardware
Riser height and clamp hardware
A 2.5 inch riser is a modest change, but it still moves the axle relative to the spring pack and driveline. Before installing, inspect the springs, shackles and bushings for wear, since they will carry the same load at a slightly higher position. Clean the mating faces of the spring pack and riser so the block seats flat.
The included hardware is designed to clamp the riser firmly to the spring pack. Flat washers spread the clamp load, so damaged or flattened ones should be replaced. Tighten the hi-nuts evenly and recheck them after the first few drives, since the pack can settle during the first miles.
- Clean mating faces before assembly
- Inspect shackles and bushings for wear
- Replace flattened or cracked washers
- Recheck hi-nuts after the first drives
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 22250 |
| UPC | 614901110203 |
| Lift height | 2.5 in |
| Riser material | Cast iron |
| Risers | 2 |
| U-bolts | 4 |
| Flat washers | 8 heavy duty |
| Hi-nuts | 8 |
| Packaging | Boxed |
Vehicle fitment
Check your leaf spring and axle setup before ordering. Confirm fit for your vehicle’s year, model and trim.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check the driveshaft angle after the kit is in, since a tapered riser is used to hold that angle at 2.5 inches.
What’s included
Two cast iron riser blocks, four U-bolts, eight heavy duty flat washers and eight hi-nuts.







