Overview
The RockJock 4×4 CE-9112N75-13 is a narrow forged Johnny Joint, a 2-inch diameter rod end with 2 1/4 inches of 3/4-16 right hand threads, made for suspension fabricators and builders. It gives 40 degrees of unrestricted movement in any direction, compared with 22 degrees on a common heim joint.
A Johnny Joint uses a high-density urethane bushing around its inner ball, providing cushioning that a standard heim joint cannot. The center balls are heat treated and cross drilled for thru bolt lubrication, and the internals are held by two heavy duty heat treated side washers and a snap ring. The joint is gold zinc plated and fitted with a zerk fitting for greasing.
Key features
- 40 degrees of unrestricted movement in any direction.
- High-density urethane bushing encases the inner ball for cushioning
- Heat treated, cross drilled center balls for thru bolt lubrication
- Two heavy duty heat treated side washers and a snap ring retain the internals
- Zerk fitting for greasing
- Gold zinc plated finish
Working with a Johnny Joint
A Johnny Joint is a rod end built to carry suspension loads while letting the link pivot through a wide arc. Its urethane bushing absorbs some shock and keeps the inner ball from knocking against the housing, which matters on rough trails where the arm sees repeated impacts. Grease reaches the inner components through the fitting, so regular greasing is part of keeping it working smoothly.
Choosing one for a build means matching the thread, the mounting width and the bolt hole to the mount you are fabricating. Heat treated center balls handle loads well, and cross drilled balls let grease reach the thru bolt. Inspect the joint after rough use, looking for cracks in the body, play at the ball, or dry bushings.
- Grease after every trail trip or water crossing
- Check the snap ring and side washers during service
- Replace joints that show play or cracked housings
Specifications
| Brand | RockJock 4×4 |
|---|---|
| Part number | R/JCE-9112N75-13 |
| Joint diameter | 2″ |
| Shank thread | 3/4″-16, 2 1/4″ long |
| Thread direction | Right hand |
| Mounting width (ball) | 1.600″ |
| Thru bolt hole | .562″ |
| Movement | 40 degrees unrestricted |
| Comparison | 22 degrees on a common heim joint |
| Lubrication | Zerk fitting |
| Finish | Gold zinc plating |
Vehicle fitment
The listed fitment is universal fit, so no vehicle year, make, model or trim is named. This joint suits custom suspension builds where a narrow forged rod end is needed. Match the 1.600″ mounting width and .562″ bolt hole to your own mount before fitting.
No vehicle is named for this joint, so it is not matched to any specific model here. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The joint takes a thru bolt through the .562″ hole, so the mount must be drilled to suit it. Grease through the zerk fitting after installation. Because the joint carries suspension loads, check the fit and full range of movement before loading the arm.
What’s included
The joint comes as one narrow forged Johnny Joint with gold zinc plating and a zerk fitting.
Not included: Thru bolts and jam nuts are not included, so source them before assembly and confirm they suit the .562-inch hole.









