Overview
The ReadyLift 66-2024 is a 4 inch rear block kit for 2011 to 2016 Ford F-250 and F-350 Super Duty trucks in 2WD and 4WD. It is sized for trucks with a 1-piece driveshaft, and the lift height varies with the factory block already on the truck.
The kit includes two rear blocks with integrated OEM style bump stops, four 15.5-inch long E-coated U-bolts and eight nuts and washers. The blocks are based on OEM designs and are not made from lightweight extrusions. It is a dually spring pack rear block that puts a slight rake back in the truck.
This kit is not intended for trucks with a service axle. Using it with aftermarket or factory add-on air bag systems that attach to the bump stop tangs voids the block warranties.
Key features
- 4 inch rear lift with OEM style blocks
- Integrated OEM style bump stops
- 15.5-inch long E-coated U-bolts
- Eight nuts and washers
- Designed for 1-piece driveshaft trucks
Dually and spring pack setups
A dually spring pack rear block suits a Super Duty with a 1-piece driveshaft that uses the dually spring pack. It raises the rear while keeping the blocks seated against the factory bump stop geometry. Because the rear end carries heavier loads, check the springs and mounting hardware carefully before installing. A truck with a service axle is not suited to this kit, so confirm the axle setup first.
After installation, inspect the U-bolts, block bolts and shackles for looseness. Keep an eye on the driveline angles at the front and rear u-joints, since the rear height changes them. A regular check of the tire wear and steering feel helps spot any issue early. If the truck will carry heavy trailers, include the rear axle hardware and the brake lines in the same inspection.
Specifications
| Brand | ReadyLift |
|---|---|
| Part number | RDY66-2024 |
| Product type | Rear block kit, dually spring pack |
| Lift height | 4 inches, varies with the factory block |
| U-bolts | Four, 15.5 inch long, E-coated |
| Driveshaft | 1-piece |
| Drive type | 2WD and 4WD |
| Fitment type | Direct fit |
| Vehicle | Ford F-250 and F-350 Super Duty, 2011 to 2016 |
Vehicle fitment
It is a direct fit for the 2011 to 2016 Ford F-250 Super Duty in the King Ranch, Lariat, Platinum, XL and XLT trims, and for the 2011 to 2016 Ford F-350 Super Duty in the same trims.
Trucks with a service axle are not covered, and the 2-piece driveshaft version is a separate kit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Do not use this kit on trucks with a service axle, and do not pair it with air spring or load leveling kits that attach to the bump stop tangs.
What’s included
The kit includes two rear blocks, four 15.5-inch long E-coated U-bolts and eight nuts and washers. A carrier bearing spacer is also part of the kit.









