Overview
The ReadyLift 69-2755 is a 2.5-inch front and rear SST Lift Kit built for the 2017 to 2020 Ford F-150 Raptor. It is a billet aluminum kit designed to bolt directly onto the factory Internal Bypass coil-overs. It is designed for 37-inch tires.
The billet coil-over spacer design is meant to keep suspension articulation while retaining factory travel. A machined billet spring pre-load spacer provides the 2.5 inches of front lift while staying within the factory droop and compression limits. The rear uses Ford-specific cast iron lift blocks, 4 inches tall, which replace the factory block. Control arm bump stops are included to limit over-droop for off-road use.
Key features
- 2.5 inches of front lift from machined billet spacers
- Billet aluminum construction that matches the factory coil-over finish
- Bolts to the factory Internal Bypass coil-overs
- Billet spring pre-load spacer
- 4-inch cast iron rear lift blocks, Ford specific
- Control arm bump stops to limit over-droop
- Designed for 37-inch tires
Billet parts and care
Billet aluminum spacers are machined for a precise fit, which suits the factory coil-overs, but they still need routine attention. Check the spacer seats and fasteners for movement after the first few off-road outings, and look for corrosion where the aluminum meets steel hardware. Keeping mating surfaces clean helps prevent galling when parts are removed later.
Raptor owners often run larger tires, so the rear block height and driveline angle deserve the most attention. Heavier tires and a lift increase load on the control arms and bump stops, which makes inspecting those parts a regular habit. Keeping a record of tire size and wheel offset also helps when clearance questions come up later.
- Check spacer fasteners after the first off-road trips
- Inspect control arm bump stops for cracks or compression
- Look for corrosion where aluminum meets steel hardware
- Recheck the driveline angle after any tire change
Specifications
| Brand | ReadyLift |
|---|---|
| Part number | RDY69-2755 |
| Front lift | 2.5 inches |
| Rear lift | 4 inches, cast iron block |
| Front spacer material | CNC-machined billet |
| Finish | Matches factory coil-over finish |
| Tire size | 37 inches |
| Fitment type | Direct fit |
Vehicle fitment
It fits 2017 to 2020 Ford F-150 Raptor trucks.
It is for Raptor models only and does not fit other F-150 trim levels. Verify that your year, model and trim match before placing an order.
Installation notes
The billet spacer sets the front height while staying within the factory droop and compression limits. The rear block replaces the factory block, so check the rear lift against driveline angles once the install is complete. An alignment should follow the lift.
What’s included
The kit includes the billet coil-over spacers, the billet spring pre-load spacer, the 4-inch cast iron rear lift blocks and the control arm bump stops.
Not included: Tires and wheels are not included. Check the wheel offset and tire choice against the installed lift.










